Brother Computerized Embroidery Machine operation manual Attaching the Embroidery Frame

————————————————————————————————————————————————————

Attaching the Embroidery Frame

This section describes how to attach the embroidery frame.

Attaching the embroidery frame

aWind the embroidery bobbin thread onto the bobbin and set it into the bobbin case.

•For details, refer to “Winding/Installing the Bobbin” (page 24).

bRaise the presser foot lever.

a

aPresser foot lever

cPass the embroidery frame under the embroidery foot while raising the presser foot lever even further.

CAUTION

●Do not hit the needle with your finger or the embroidery frame. It may cause injury or needle breakage.

dWhile lightly holding the lever on the frame holder to the left, align the two pins on the embroidery frame holder with the mounting brackets on the frame, and then press the frame into the embroidery frame holder until a click is heard.

After pressing the front mounting bracket onto the pin so that it clicks into place, press the back mounting bracket into place.

1

2

1

aLever

1

2

2

aMounting brackets

bPins

3

Note

zBe sure to insert both pins. If only the forward or the back pin is inserted, the pattern may not turn out correctly.

CAUTION

●Correctly set the embroidery frame into the embroidery frame holder. Otherwise, the embroidery foot may hit the embroidery frame, resulting in injury.

Attaching the Embroidery Frame 47