Brother Computerized Embroidery Machine operation manual Attaching the Embroidery Foot

APPENDIX ——————————————————————————————————————————————

Attaching the Embroidery Foot

This section describes how to attach the embroidery foot.

Attaching the embroidery Foot “Q”

Attach the embroidery foot “Q” when embroidering. Have the included embroidery foot “Q” and a screwdriver ready.

1

2

aEmbroidery foot bar

bCaught by the presser foot holder screw

CAUTION

●Always use the embroidery foot “Q” when embroidering. If the wrong presser foot is used, the needle may hit the presser foot and break or bend.

aPress (Needle position button) once or twice to raise the needle.

1

aNeedle position button

bTurn off the machine.

CAUTION

●Before attaching the embroidery foot, be sure to turn off the machine, otherwise

injuries may occur if (Start/stop button) is accidentally pressed and the machine starts embroidering.

cRaise the presser foot lever.

a

aPresser foot lever

XThe embroidery foot is raised.

•At the time of purchase, the presser foot lever is up.

dHold the embroidery foot with your right hand, as shown.

Hold the embroidery foot with your index finger wrapped around the lever at the back of the foot.

a

aLever

eWhile pressing in the lever with your finger, fit the embroidery foot bar over the needle clamp screw to attach the embroidery foot to the presser foot bar.

1

2

aEmbroidery foot bar

bNeedle clamp screw

72