18T Series Installation
1 Jetted Shower XO™ Jet Module Trim Installation
A.
1
2
1
B.
1
2
3
4
Turn off water supplies. Unscrew test caps (1) from the body. If this is not a thin wall mounting, the entire plasterguard may be removed. IMPORTANT: NOTE COLOR
OF BASE ON STEM EXTENDER (2) FOR USE LATER. (SEE CHART BELOW FOR REFERENCE.)
Thread sleeve (1) onto brass body, use wrench to tighten. Place the oval escutcheon (2) over jet body module. Thread the jet sleeve assemblies (3) onto the jet body module. Use wrench (4) to tighten the sleeve assemblies. caution: Do not overtighten. Tighten until the escutcheon IS flat against the wall.
C.
3 4
6
2
5
7
1 
6
A B C
Select proper label (1), the 3 position label B (used with the blue stem extender) or 6 position label C (used with the black stem extender) and assemble onto trim ring (2). (See chart below for proper label selection.) Slide trim ring onto sleeve (3) until it bottoms out on the escutcheon (4). Install handle (5) onto stem, tighten set screw to secure. Thread the bonnet assemblies (6) onto the jet sleeve assemblies (7).
| Jetted | Jetted Shower | ||
| Shower™ | XO™ | ||
|
|
|
| |
|
| 2 Ports | 3 Ports | |
|
|
|
| |
Stem | White | Blue | Black | |
Extender | ||||
|
|
| ||
|
|
|
| |
Label | A | B | C | |
|
|
|
| |
16