18 Series Installation - Single Unit
2 Jetted Shower XO™ Trim Installation
A.
2
1
1
B.
1
4
2
5
3
Turn off water supplies. Unscrew test caps (1) from the body. If this is not a thin wall mounting, the entire plasterguard may be removed. IMPORTANT: NOTE COLOR
OF BASE ON STEM EXTENDER (2) FOR USE LATER. (SEE CHART BELOW FOR REFERENCE.)
Thread sleeve (1) onto brass body, use wrench to tighten. Place escutcheon (2) over jet body module. Install screws (3).
Thread the jet sleeve assemblies (4) onto the jet body module. Use the wrench (5) to tighten the sleeve assemblies. caution: Do not overtighten. Tighten until the escutcheon IS flat against the wall.
C.
3 4
6
2
5
7
1
A B C
Select proper label (1), the 3 position label B (used with the blue stem extender) or 6 position label C (used with the black stem extender) and assemble onto trim ring (2). (Refer to chart below for proper label selection.) Slide trim ring onto sleeve (3) until it bottoms out on the escutcheon (4). Install handle (5) onto stem, tighten set screw to secure. Thread the bonnet assemblies (6) onto the jet sleeve assemblies (7).
| Jetted | Jetted Shower | ||
| Shower™ | XO™ | ||
|
|
|
| |
|
| 2 Ports | 3 Ports | |
|
|
|
| |
Stem | White | Blue | Black | |
Extender | ||||
|
|
| ||
|
|
|
| |
Label | A | B | C | |
|
|
|
| |
12