8-3. AUTO RESTART FUNCTION
When the indoor unit is controlled with the remote controller, the operation mode, the set temperature, and the fan speed are memorized by the indoor electronic control P.C. board. “AUTO RESTART FUNCTION” automatically starts operation in the same mode just before the shutoff of the main power.
Operation
1If the main power has been cut, the operation settings remain.
2After the power is restored, the unit restarts automatically according to the memory.
(However, it takes at least 3 minutes for the compressor to start running.)
How to release “AUTO RESTART FUNCTION” 1Turn OFF the main power for the unit.
2Solder the Jumper wire to JR07 on the indoor electronic control P.C. board. (Refer to
CN130
IC156
CN212 
CN1R1 CN211
JR07
CN1U1 
CN151 CN1T1 CN112
NOTE :
•The operation settings are memorized when 10 seconds have passed after the indoor unit was operated with the remote controller.
•If main power is turned OFF or a power failure occurs while AUTO START/STOP timer is active, the timer setting is can- celled.
•If the unit has been OFF with the remote controller before power failure, the auto restart function does not work as the power button of the remote controller is OFF.
•To prevent breaker OFF due to the rush of starting current, systematize other home appliance not to turn ON at the same time.
•When some air conditioners are connected to the same supply system, if they are operated before power failure, the starting current of all the compressors may flow simultaneously at restart.
Therefore, the special
8-4. REMOTE CONTROLLER
Be sure to set the slide switch inside the remote controller to an appropriate position in accordance with the installed position of the indoor unit. If the switch is not set correctly, the air conditioner may not function properly.
Slide swich
Where is the indoor unit installed in your room?
Area | Left | Center | Right |
Position of |
|
|
|
the slide |
|
|
|
switch |
|
|
|
Display on |
|
|
|
the remote |
|
|
|
controller |
|
|
|
Installed at left, if the | Installed at right, if the |
distance is not more | distance is not more |
than 50 cm. | than 50 cm. |
(Left) | (Center) | (Right) |
Is the indoor unit in- stalled at right, left or center?
NOTE:If the indoor unit is installed more than 50 cm away from the side walls, cabinets or other nearby objects, set the slide switch to the “center” position.
10