INSTALLATION Solid Pipe Installation
FITTING THE APPLIANCE AND CABINET.
1 | Make suitable arrangements for gas and electrical supplies into the installation site. Preferably a junction | |||||
| box or a 3 pin earthed socket should be situated at the back of the cabinet below the oven. | |||||
2 | Fit cabinet as Fig. 1, making sure that it is level. |
| ||||
3 | When unpacking the oven keep it on it's polystyrene base until it is put into the cabinet to avoid damage. | |||||
| NOTE: It is imperative that the appliance is left in the base to protect both the appliance and the floor. | |||||
4 | Remove the oven door. (See section B on page 44). |
| ||||
5 | Solid gas pipe installation: |
|
|
|
| |
| i) Remove the fascia control panel. (See section A on page 43). |
| ||||
| ii) Slacken and remove the union nut on the gas supply elbow on the right hand side of the control | |||||
|
| panel. See Fig.7. |
|
|
|
|
| iii) Remove the two screws on the gas inlet |
| ||||
|
| block Fig.3. |
|
|
| GAS INLET SUPPLY BLOCK |
| iv) | Withdraw the gas inlet block and | pipe | |||
|
| |||||
|
| assembly from the back of the appliance |
| |||
| v) Remove the union | elbow from the inlet |
| |||
|
| block and pipe assembly. The elbow | will |
| ||
|
| be required in the final installation. |
|
| ||
| vi) | The union elbow should be connected to |
| |||
|
| the gas supply pipe via a standard |
| |||
|
| ¼"B.S.P. straight connector. |
|
|
| |
6 | Install the gas supply pipe on site complete with |
| ||||
| the union elbow (See Fig.4). | Note the |
| |||
| orientation of the elbow, | the connection must |
| |||
| be upwards. |
|
|
|
| |
7 | Position the appliance in front of the cabinet and |
| ||||
| run the supply cable (See Section 2) through | 120 | ||||
| the cabinet and connect to the junction box or | |||||
|
| |||||
| socket. Ensure that the supply is isolated at this |
| ||||
| stage. |
|
|
| FIG.3 | |
| N.B. Two people will be required to carry | |||||
| 120 | |||||
| out the lifting procedure. |
|
|
Warning: Do not attempt to lift this appliance by the handle.
8Lift the appliance into the cabinet making sure the gas supply pipe enters the duct in the rear of the appliance and the cable is not
trapped | by the appliance. Push the | 75 | FIG.4 | 225 |
appliance as far back as it will go. |
|
| mm | |
Ensure the supply pipe comes |
|
|
| |
through the control panel and pull |
|
|
| |
through any slack cable. |
|
|
| |
9 Centralise and fix the appliance to the |
| 500 |
| |
cabinet | using four wood screws in |
|
|
the position indicated in Fig.2. NOTE: If fitting the cabinet heat deflectors
they should be located behind the front frame and secured in position by the above four wood screws.
10Tighten the union nut into the supply elbow.
11Carry out gas soundness check
NOTE: Check supply pressure before fitting fascia (See Section 3).
41