Sani Rinse
Select this option to raise the water temperature in the final rinse to approximately 160°F (71°C) for 10 minutes. Sani Rinse adds heat and time to the cycle. In the Normal cycle, this high- temperature rinse sanitizes your dishes and glassware in accordance with the NSF International Protocol for Sanitization and Cleaning Performance of Household
NOTE: Sani Rinse is an option with the Heavy and Normal cycles.
Energy Saver Dry
Select this option to dry dishes without heat and save energy. Energy Saver Dry is useful when loads contain plastic dinnerware that may be sensitive to high temperatures.
The dishes take longer to dry and some spotting can occur. For best drying, use a liquid rinse aid. Some items (such as plastics) may need towel drying.
NOTE: Rinse Only automatically uses this option. Energy Saver Dry is an option with all other cycles.
Control Lock
Use Control Lock to prevent your dishwasher from accidentally being turned on. Use Control Lock, also, to prevent accidental cycle or option changes during a cycle.
When CONTROL LOCK is lit, all buttons are disabled.
NOTES:
■The dishwasher door can be opened while the controls are locked.
■You can turn on the Lock while the dishwasher is running.
To turn on the Lock
Press and hold
for 4 seconds. CONTROL LOCK glows.
If you press any pad while your dishwasher is locked, the light flashes 3 times.
To turn off the Lock
Press and hold ENERGY SAVER DRY for 4 seconds. The light turns off.
Delay Hours
Select this option to run your dishwasher at a later time or during
To delay the start
1.Close the door.
2.Select a wash cycle and options.
Press DELAY HOURS 1 time for a
2 4 8
The number glows above Delay Hours. The dishwasher starts the cycle in the selected number of hours.
3.Press START.
NOTE: To cancel the delay, press DELAY HOURS until no number is lit or press START.
IMPORTANT:
■Operate your dishwasher only when you are at home.
■If your home is equipped with a water softener, do not start the dishwasher during the regeneration of the softener.
Status Indicators
Follow the progress of your dishwasher with the Status indicators.
/
Sensing/Soak
Your dishwasher senses the soil level on the dishes. Soil level determines the length of some cycles, the amount of heat or water added, and the cycle needed for the load. Soaks help loosen soils on the dishes.
SENSING/SOAK glows during the sensing and soak parts of the cycle. Wash action continues while sensing occurs. Wash action pauses during a soak.
Water Heating
WATER HEATING glows, and the cycle progression pauses, whenever water is heated to a set temperature during a cycle.
Wash or rinse action continues as the water heats.
Clean
CLEAN glows when a cycle is finished. The light turns off when you open and close the door or press Cancel/Drain.
Sanitized
If you select the Sani Rinse option, SANITIZED glows when the Sani Rinse cycle is finished. If your dishwasher did not properly sanitize your dishes, the light flashes at the end of the cycle. This can happen if the cycle is interrupted or the incoming water temperature is too low. The light goes off when you open and close the door.
13