Prepare dishwasher

WARNING

Tip Over Hazard

Do not use dishwasher until completely installed. Do not push down on open door.

Doing so can result in serious injury or cuts.

WARNING

Excessive Weight Hazard

Use two or more people to move and install dishwasher.

Failure to do so can result in back or other injury.

1.Put corner posts from packaging behind dishwasher. Grasp sides of dishwasher door frame and put dishwasher on its back, resting on top of the corner posts.

2.Remove two screws attaching access panel and lower panel to dishwasher using a 1/4” hex socket, nut driver or Phillips screwdriver.

7.Remove terminal box cover.

–If you are direct wiring: install a U.L.-listed/CSA- certified clamp connector to the terminal box. If using conduit, use a U.L.-listed/CSA-certified conduit connector.

–If you are installing a power supply cord kit, do so now, following kit instructions.

terminal

box cover

ADVERTENCIA

AVERTISSEMENT

cable clamp connector

dishwasher wires

Helpful Tip: Put cardboard under dishwasher until it is installed in cabinet opening. The cardboard will help protect floor covering during

installation.

8. Measure height of cabinet opening from underside of countertop to floor where dishwasher will be installed (you need the lowest point). Check chart for that height opening. Put wheels in the required position.

	Minimum	Wheel	Number of
	Minimum	Wheel	turns on
1	cutout height	position	turns on
	cutout height	position	front leg
			front leg
2	34" (86.4 cm)	1	10
3	34-1/4" (87 cm)	2	5
wheel	34-1/2" (87.6 cm)	3	0

access panel

lower panel

grounding clip

3.	Remove panels and set panels
	aside on a protective surface.
4.	Check that grounding clip is
	attached to the lower panel.

water inlet valve

9.Turn both front leveler legs to the same height.

If the minimum cutout height is less than 34” (86.4 cm), the rear wheels can be removed for additional clearance. This will allow the dishwasher to fit into a 33-7/8”

(86 cm) high cutout, but the dishwasher will

be more difficult to move into position. If front leg the wheels are removed, protect the floor

when moving the dishwasher.

If you have built-up floors

5.	Apply Teflon® tape or pipe
	joint compound to 90° elbow
	fitting and connect fitting to
	water inlet valve.
6.	Tighten elbow until snug, and
	be sure that it faces to the rear.

elbow

1.Measure height of opening from underside of countertop to built-up floor. If the height is at least 33-3/4” (85.7 cm), the dishwasher will fit into the opening without modification to the countertop or flooring.

2.Put wheels in position 1 and turn the front leveler legs up all the way.

countertop

33-3/4"

(85.7 cm)

min.

built-up

floor

shim