KitchenAid 8574116 guide

11.Align the top edge of the customer-supplied custom panel with the top of the console.

12.Drill two 3/32" pilot holes 1/2" (13 mm) deep, into the customer-supplied custom panel, through the holes in the top corners on the inner panel, as shown.

1.With a T-15 TORX® screwdriver, remove three screws from both sides of door; save screws for reinstallation. Hold the outer panel up while removing the screws.

2.Remove four screws from the latch area and top corners of inner panel.

13. Install the two #8-18 x 1-3/8" screws from the literature package in the top corners of the inner panel.

inner panel

align top edges

drill through these holes

1-3/8"screw

3 screws

3 screws	4 screws

outer panel

3. Partially close dishwasher door; tilt outer door panel

outward to lift up and remove. Gently set outer panel

aside.

14.Tighten the six side screws reinstalled in Step 10.

Option 2: For models KUDI02FR, KUDP02FR, KUDS02FR, KUDU02FR

All models require an accessory option to attach custom panels. Kit No. 8212489 (black) or Kit No. 8212553 (stainless steel) are available. To order, contact customer service at 800-444-1230.

NOTE: A customer-supplied full front custom panel must weigh no more than 16 pounds (7.3 kg) and must be made to specific dimensions. It is recommended that a cabinetmaker cut the custom panel because of the precise dimensions needed.

NOTE: All mounting hardware supplied is for a 3/4"

(19.1 mm) thick wood panel. If a thinner wood panel, or materials other than wood are used, it is the consumer’s responsibility to obtain the proper length screws and adjust the pilot holes accordingly.

IMPORTANT: Use a moisture resistant sealer on both sides and all edges of the panel to protect it from humidity.

23-3/8" (59.4 cm)

*30" (76.2 cm)

custom panel dimensions

3/4" (19.1 mm)

*This dimension is for 4" (10.2 cm) toe kick. If the installation needs a higher toe kick, adjust the height of the wood panel accordingly. Not recommended for toe kicks greater than 6" (15.2 cm).

4.	Lay the cutomer-supplied custom panel face down on a
	protective, non-scratching surface.
5.	Measure 9-29/32" (25.2 cm) from top edge of customer-
	supplied custom panel and mark a line on the back of
	panel.

back	9-29/32"
	(25.2 cm)
mark line	top edge

6.Position the outer panel on the back of the customer- supplied custom panel as shown, so that the top holes in the outer panel are on the line, and both panels are centered side to side.

7.Mark all four hole locations; remove outer panel and drill 3/32" pilot holes 1/2" (13 mm) deep, in customer-supplied custom panel.

8.Place the outer panel on the back of the customer- supplied custom panel; align holes.

mark pilot holes

9.Attach outer panel to back of customer-supplied custom panel with the four #10-16 x 3/8" hex head

screws supplied in the literature package.

hex head

screw