4.As the dishwasher is being pushed into the opening, slowly pull the inlet hose, drain hoses and power supply cord through the utility hole.
5.Remove the strap/tape from upper drawer.
Go to “If Installing Flexible Trim Pieces” section.
Option 2: Direct Wiring Method
WARNING
Electrical Shock Hazard
Disconnect electrical power at the fuse box or circuit breaker box before installing dishwasher.
Failure to do so can result in death or electrical shock.
WARNING
Excessive Weight Hazard
Use two or more people to move and install dishwasher. Failure to do so can result in back or other injury.
1.Place cardboard or other protective covering on the floor in front of cabinet opening. Place the dishwasher on covering.
2.Disconnect power.
3.Open the bottom drawer.
4.Press in the
NOTE: When removing the drawer there is limited range of movement due to the attached water hoses.
6.Rotate drawer to the right onto its side and place on the protective cover.
electrical cover
7.Slide the
8.The electrical cover is located in the back left corner.
Use a flat blade screwdriver to press the release button. Slide the cover to the right and then pull up.
electrical cover
press
release button
Remove factory-installed power cord.
1.Disconnect the black and white wires of the power cord from the terminal block.
strain relief
runner clip
5.Lift the right edge of the drawer off its runner. Slide that runner back into the dishwasher. Lift the drawer completely off the
| green ground screw | |
terminal block | ||
| ||
|
|
2.Use a 7 mm socket wrench to remove the green ground screw. Remove the green ground wire.
3.Use a Phillips screwdriver to remove the strain relief screw. Open the strain relief.
4.Pull the power supply cord off the dishwasher through the back of the dishwasher.
5.Close the strain relief and replace screw so it does not interfere with the electrical cover.
6