KitchenAid 528879, 8573755 A If Installing Flexible Trim Pieces, Install Dishwasher

Page 8

18.Use the side cutting pliers to cut the cable tie securing the hoses and power supply cord to the back of the dishwasher.

back of

dishwasher

cable tie

19.Completely remove the power supply cord and save it, in case a power cord installation is needed in the future.

WARNING

Tip Over Hazard

Do not use dishwasher drawer until inside cabinet opening.

Doing so can result in serious injury or cuts.

WARNING

Excessive Weight Hazard

Use two or more people to move and install dishwasher. Failure to do so can result in back or other injury.

20.Place cardboard or other protective covering on the floor in front of cabinet opening. Place the dishwasher on covering.

21.Begin to route the hoses through the utility hole in the cabinet.

IMPORTANT: Push against the outside edges of drawers as shown. Do not push against the center of the drawers.

22.Push dishwasher part way into the opening.

23.As the dishwasher is being pushed into the opening, slowly pull the inlet hose and drain hoses through the utility hole. Let the house wiring gather behind the dishwasher.

24.Remove the strap/tape from upper drawer.

8

If Installing Flexible Trim Pieces

If the cabinet opening is 24" wide x 34-1/2" high (61.0 cm x

87.6cm), flexible trim pieces can be attached along the top and sides of the dishwasher. Top and side trim pieces are different lengths.

1.Open the drawers to expose the chassis trim.

2.Center the flexible trim pieces.

 

 

 

 

 

 

side trim

 

 

 

 

 

 

 

piece

 

 

 

 

chassis

 

 

 

 

 

 

 

trim

 

 

 

 

 

 

 

edge

 

 

 

 

 

 

 

 

 

lip

 

 

 

 

 

 

 

side trim

 

 

top trim

 

 

 

 

 

piece

 

piece

 

 

side trim

 

 

 

 

 

 

 

 

piece

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

open drawer

chassis trim

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

edge

 

 

 

 

 

 

 

 

 

3.If using the optional top attaching brackets, place the trim pieces under the attaching brackets.

4.Remove trim pieces backing paper to expose the adhesive.

5.Place the trim pieces on the trim and press.

6.Finish pushing dishwasher into opening.

Install Dishwasher

1.Leave protective cover on floor.

2.Open the bottom drawer.

3.Press in the right-hand runner clip and push it back about 6" (15.2 cm). Repeat with the left-hand runner clip.

NOTE: When removing the drawer there is limited range of movement due to the attached water hoses.

runner clip

4.Lift the right edge of the drawer off its runner. Slide that runner back into the dishwasher.

5.Lift the drawer completely off the left-hand runner.

6.Rotate the drawer to the right onto its side and place on the protective cover.

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Installation Instructions Drawer Dishwasher 528879/8573755 aDrawer Dishwasher Safety Table of ContentsInstallation Requirements Product dimensionsTools and Parts Location RequirementsCabinet dimensions/requirements Water Supply RequirementsElectrical Requirements For a grounded, cord-connected dishwasherInstallation Instructions Option 1 Power Supply Cord MethodPrepare Cabinet Opening Electrical ConnectionOption 2 Direct Wiring Method Remove factory-installed power cordRemove the house wiring knockout If Installing Flexible Trim Pieces Install DishwasherChoose attachment option Slide the left-hand runner back into the dishwasherOption 1 Side attachment Option 2 Top attachmentOption 1 Sink drain waste tee connection Install the Drain HoseOption 2 Garbage disposal connection Install Drawer Door Panels and Toe Panel Option 1 Install standard door panels on some modelsConnect to Water Supply Option 3 Air break connectionOption 1 Install standard toe panel Bottom edge of the toe panelFloor If not, remove the toe panel and shortenOption 2 Install custom door panels on some models Custom door panel dimensionsOption 2 Install custom toe panel on some models Custom toe panel dimensionsConnect the medallion connector to the dishwasher Connector Repeat steps 2-15 for other custom door panelComplete Installation If dishwasher does not operate, check the following528879/8573755 Rev. a Instructions d’installation Lave-vaisselle tiroir 528879/8573755ASécurité DU LAVE-VAISSELLE Tiroir Table des matièresOutillage et pièces Exigences DinstallationEmplacement d’installation Pour un lave-vaisselle branché en permanence Spécifications de l’alimentation en eauSpécifications électriques Instructions Dinstallation Préparation de la cavité d’installationMéthode recommandée de liaison à la terre Raccordement électriqueEnlever le cordon d’alimentation installé à l’usine Option 2 Méthode par câblage directAvertissement Cas de linstallation de moulures Extrudées flexibles Installation du lave-vaisselleOption 1 Fixation latérale Options de fixation’arrière Option 2 Fixation supérieure LinstallationRaccordement à la canalisation dévacuation Option 3 Connexion au brise-siphon Raccordement à la source dalimentation en eauOption 2 Connexion sur le broyeur à déchets Panneau Avant inférieur Option 1 Installation de la planche de plinthe standard Éliminer les bavures sur l’arête deDimensions des panneaux avant personnalisés Dimensions de la planche de plinthe personnalisée Placer le panneau avant personnalisé face vers le basAchever l’installation 528879/88573755 Rév. a

528879, 8573755 A specifications

The KitchenAid 8573755 A,528879 is a versatile and powerful appliance designed to elevate the culinary experience in any kitchen. With its robust performance and innovative technologies, it caters to both amateur cooks and seasoned chefs alike.

One of the standout features of the KitchenAid 8573755 is its powerful motor, engineered for heavy-duty tasks. This ensures that the appliance can easily handle tough mixing and kneading, making it ideal for bread dough and other thick mixtures. The direct drive transmission allows for consistent performance, ensuring that users can achieve their desired results with minimal effort.

Incorporating advanced planetary mixing action, the KitchenAid 8573755 rotates the bowl in one direction while the beater rotates in the opposite direction. This unique feature ensures thorough mixing and even incorporation of ingredients, significantly reducing preparation time. Home cooks will appreciate how quickly and efficiently tasks such as whipping cream or mixing batter can be completed.

The KitchenAid 8573755 also comes with a variety of attachments, increasing its versatility. From a dough hook to a flat beater and wire whip, these accessories expand the kitchen's functionality, allowing users to whip, beat, knead, and mix with ease. Additionally, the compatibility with a wide range of optional attachments, such as pasta makers and food grinders, transforms the appliance into a multifunctional tool that can accommodate numerous culinary tasks.

Aesthetically, the KitchenAid 8573755 boasts a classic and timeless design that fits seamlessly into any kitchen decor. Its robust construction ensures durability, while the smooth surface makes cleaning a breeze. The appliance is also equipped with a tilt-head design, making it easy to access the bowl and add ingredients without hassle.

Safety is also a priority with the KitchenAid 8573755, featuring a power hub that allows for easy attachment of various tools and minimizing any risk during operation.

In summary, the KitchenAid 8573755 A,528879 combines power, versatility, and elegance, making it a must-have for anyone looking to enhance their cooking experience. With its robust features, advanced technologies, and focus on user convenience, this appliance stands out as a reliable companion in the kitchen.
Top Page Image Contents