KitchenAid 8573755 A, 528879 Installation Requirements, Tools and Parts, Location Requirements

Page 3

INSTALLATION REQUIREMENTS

Tools and Parts

Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here.

Location Requirements

IMPORTANT: Observe all governing codes and ordinances. Failure to meet codes and ordinances could lead to fire or electrical shock.

Proper installation is your responsibility:

Tools needed:

■Utility knife

■Needle-nose pliers

■Tape measure

■Flat-bladed screwdriver

■#2 Phillips screwdriver

■Side cutting pliers

■Pencil

■Sandpaper

■Level

■Wood cutting board

■Adjustable wrench that opens to 1¹⁄₈" (29 mm)

Parts supplied:

Located in bottom drawer:

■7 mm socket wrench

■5 mm socket wrench

■5 mm open end or box end wrench

■Electric or hand drill

■1¹⁄₂" hole saw

■Valve (sized to fit hot water supply line) with ³⁄₈" male compression fitting

■Protective floor covering

■Contact a qualified installer to ensure that the dishwasher is installed to meet all electrical and plumbing national and local codes and ordinances.

■Install the dishwasher as specified in these instructions.

■Have everything you need to properly install dishwasher.

■Protect dishwasher and water lines leading to dishwasher against freezing. Damage from freezing is not covered by the warranty.

■This dishwasher is manufactured for indoor use only.

■Install and level dishwasher on a floor that will hold the weight, and in an area suitable for its size and use.

Product dimensions

22⁷⁄₁₆" *

23⁷⁄₁₆"

(57 cm)

(59.5 cm)

■2 flexible trim pieces (for sides)

■1 flexible trim piece (for top)

■Edge protection

■Hose clamp, screw type

■Washer

■2 installation brackets (top)

■Drain hose support

■Drain hose connector

■2 hose clamps, wire type

■24 #8 Phillips head wood screws

■Toe panel

■Custom toe panel mounting bracket (on some models)

■Moisture protection tape

raised tabs for

optional top

attaching brackets

 

 

32³⁄₁₆" -

30" ***

 

 

34¹⁄₂"

(76.2 cm)

 

 

(81.8 cm -

 

 

87.8 cm)

 

 

 

side

attaching

tabs

2"– 4³⁄₈" **

20¹⁵⁄₃₂"(5 cm – 11 cm)

(52 cm)

drawer open

*If custom wood panels are to be used, the product depth is specified with an ¹¹⁄₁₆" (18 mm) door panel thickness.

**Toe panel depth: Factory supplied, 2–4 ³⁄₈" (5 – 11 cm); Custom wood, 5"

(12.7 cm) less the toe panel thickness for integrated. Minimum panel thickness using the supplied screws is ³⁄₈" (9 mm).

***Door front height: Factory supplied – 30" (76.2 cm); Custom wood – 28¹⁄₄" (71.8 cm) minimum.

NOTE: Product shown with front panels for dimension purposes.

Greatest length from product exit point to hookup (does not include allowance for drain loop):

■Drain hose 88 ⁹⁄₁₆” (2250 mm): Extension kit available - part

■no. 8194400

■Inlet hose 68 ⁷⁄₈” (1750 mm)

■Power cord 44” (1125 mm)

3

Page 2 Page 4
Image 3
Page 2 Page 4
Contents 528879/8573755 a Installation Instructions Drawer DishwasherTable of Contents Drawer Dishwasher SafetyLocation Requirements Installation RequirementsProduct dimensions Tools and PartsFor a grounded, cord-connected dishwasher Cabinet dimensions/requirementsWater Supply Requirements Electrical RequirementsElectrical Connection Installation InstructionsOption 1 Power Supply Cord Method Prepare Cabinet OpeningRemove factory-installed power cord Option 2 Direct Wiring MethodRemove the house wiring knockout Install Dishwasher If Installing Flexible Trim PiecesOption 2 Top attachment Choose attachment optionSlide the left-hand runner back into the dishwasher Option 1 Side attachmentInstall the Drain Hose Option 2 Garbage disposal connectionOption 1 Sink drain waste tee connection Option 3 Air break connection Install Drawer Door Panels and Toe PanelOption 1 Install standard door panels on some models Connect to Water SupplyIf not, remove the toe panel and shorten Option 1 Install standard toe panelBottom edge of the toe panel FloorCustom door panel dimensions Option 2 Install custom door panels on some modelsRepeat steps 2-15 for other custom door panel Option 2 Install custom toe panel on some modelsCustom toe panel dimensions Connect the medallion connector to the dishwasher ConnectorIf dishwasher does not operate, check the following Complete Installation528879/8573755 Rev. a 528879/8573755A Instructions d’installation Lave-vaisselle tiroirTable des matières Sécurité DU LAVE-VAISSELLE TiroirExigences Dinstallation Emplacement d’installationOutillage et pièces Spécifications de l’alimentation en eau Spécifications électriquesPour un lave-vaisselle branché en permanence Raccordement électrique Instructions DinstallationPréparation de la cavité d’installation Méthode recommandée de liaison à la terreOption 2 Méthode par câblage direct Enlever le cordon d’alimentation installé à l’usineAvertissement Installation du lave-vaisselle Cas de linstallation de moulures Extrudées flexiblesOptions de fixation ’arrièreOption 1 Fixation latérale Linstallation Raccordement à la canalisation dévacuationOption 2 Fixation supérieure Raccordement à la source dalimentation en eau Option 2 Connexion sur le broyeur à déchetsOption 3 Connexion au brise-siphon Panneau Avant inférieur Éliminer les bavures sur l’arête de Option 1 Installation de la planche de plinthe standardDimensions des panneaux avant personnalisés Placer le panneau avant personnalisé face vers le bas Dimensions de la planche de plinthe personnalisée528879/88573755 Rév. a Achever l’installation

528879, 8573755 A specifications

The KitchenAid 8573755 A,528879 is a versatile and powerful appliance designed to elevate the culinary experience in any kitchen. With its robust performance and innovative technologies, it caters to both amateur cooks and seasoned chefs alike.

One of the standout features of the KitchenAid 8573755 is its powerful motor, engineered for heavy-duty tasks. This ensures that the appliance can easily handle tough mixing and kneading, making it ideal for bread dough and other thick mixtures. The direct drive transmission allows for consistent performance, ensuring that users can achieve their desired results with minimal effort.

Incorporating advanced planetary mixing action, the KitchenAid 8573755 rotates the bowl in one direction while the beater rotates in the opposite direction. This unique feature ensures thorough mixing and even incorporation of ingredients, significantly reducing preparation time. Home cooks will appreciate how quickly and efficiently tasks such as whipping cream or mixing batter can be completed.

The KitchenAid 8573755 also comes with a variety of attachments, increasing its versatility. From a dough hook to a flat beater and wire whip, these accessories expand the kitchen's functionality, allowing users to whip, beat, knead, and mix with ease. Additionally, the compatibility with a wide range of optional attachments, such as pasta makers and food grinders, transforms the appliance into a multifunctional tool that can accommodate numerous culinary tasks.

Aesthetically, the KitchenAid 8573755 boasts a classic and timeless design that fits seamlessly into any kitchen decor. Its robust construction ensures durability, while the smooth surface makes cleaning a breeze. The appliance is also equipped with a tilt-head design, making it easy to access the bowl and add ingredients without hassle.

Safety is also a priority with the KitchenAid 8573755, featuring a power hub that allows for easy attachment of various tools and minimizing any risk during operation.

In summary, the KitchenAid 8573755 A,528879 combines power, versatility, and elegance, making it a must-have for anyone looking to enhance their cooking experience. With its robust features, advanced technologies, and focus on user convenience, this appliance stands out as a reliable companion in the kitchen.
Top Page Image Contents