12.Feed the medallion wires through the wire opening in the metal plate.
17.Slide the metal plate tabs into the notches and slots on the dishwasher and gently pull up to lock in place.
metal plate
wire opening
door panel
13.Lay the metal plate on the back of the custom door panel.
14.Align the centerline marked on the custom door panel with the diamond shape and notch in the metal plate to center the metal plate horizontally. Align the horizontal line with the top of the metal plate.
horizontal line
top of plate
centerline
18.Line up the bracket holes with the pin holes and replace each pin so that the pin line is vertical.
pin 
19.Repeat steps 2–15 for other custom door panel.
Option 2: Install custom toe panel (on some models)
Custom toe panel dimensions
15. Using the screws provided, fasten the metal plate to the door |
2⁵⁄₃₂"
23¹⁄₂" (59.7 cm)
panel through the 3 inner holes (per side). |
(55 mm)
5" (12.7 cm)
max.
(varies)
17" (43.2 cm) 
¹⁄₂" (12.7 mm) radius
3 inner holes 
16.Connect the medallion connector to the dishwasher
connector.
lower door panel
end of medallion connector
The black prefinished toe panel can also have a custom front panel with a thickness from ³⁄₈" to ³⁄₄"
Determine the height of the toe panel custom panel: The minimum height is 2³⁄₄" (70.5 mm). Measure from the top of the adjacent cabinet door front to the floor. Subtract 28¹⁵⁄₃₂"
(72.3 cm) for needed toe panel height.
NOTES: Depending on countertop height, you may not have to trim the toe panel.
Rugs placed in front of dishwasher could interfere with toe panel. Clearance between floor and toe panel may need to include the rug thickness.
1.Prepare the custom toe panel to specifications shown above.
2.Lay the custom toe panel face down.
14