KitchenAid 528879, 8573755 A Install the Drain Hose, Option 2 Garbage disposal connection

Install the Drain Hose

NOTE: Drain hoses will need to be separated to satisfy kosher requirements. Confirm acceptability with your local Rabbi in respect of kosher installations.

A drain hose extension kit, part no. 8194400, will extend the drain hose to a length of up to 141 ³⁄₄” (360.05 cm). Do not extend beyond this length. The maximum drain height is 37 ¹⁄₂”

(95.25 cm).

Option 2: Garbage disposal connection

1.Route the drain hoses as shown and press the hoses into the drain hose support.

2.Decide if the drain hoses need to be trimmed. If they do, trim them.

wire clip

3.Slip a wire clip over each drain hose.

Push the hoses into the drain hose connector firmly,

5 clicks.

Option 1: Sink drain waste tee connection

1. Route the drain hoses as shown and press the hoses into the drain hose support.

2. Decide if the drain hoses need to be	wire clip
trimmed. If they do, trim them.

3.Slip a wire clip over each drain hose.

Push the hoses into the drain hose connector

wire clip

drain hose connector

firmly, 5 clicks.

4. Position the wire clips between the	wire clip
two positioning ribs on the drain
	drain hose
hose connector.	connector

5.	Attach the drain hose connector to the garbage disposal
	using the supplied hose clamp.
6.	Attach the drain hose support bracket to the cabinet with a
	#8 Phillips head screw at the height shown below.
	IMPORTANT: The drain hose connector must not support the
	weight of excess hoses. A drain loop must be provided as
	shown in the Installation Instructions. Keep hoses as fully

4.Position the wire clips between the two positioning ribs on the drain hose connector.

5.Attach the drain hose connector to the waste tee using the supplied hose clamp.

6.Attach the drain hose support bracket to the cabinet with a #8 Phillips head screw at the height shown below.

IMPORTANT: The drain hose connector must not support the weight of excess hoses. A drain loop must be provided as shown in the Installation Instructions. Keep hoses as fully extended as possible to prevent sagging. Any excess length of hose should be kept on the dishwasher side of the drain loop.

extended as possible to prevent sagging. Any excess length

of hose should be kept on the dishwasher side of the drain

loop.

drain hose support

drain hose support

27 ¹⁄₂" – 32¹⁄₄" (70 cm – 82 cm)

6" (15.2 cm) minimum

waste

waste

tee

water supply

Keep drain hose straight as shown.

27 ¹⁄₂" – 32¹⁄₄" (70 cm – 82 cm)

6" (15.2 cm)

minimum

garbage disposal

valvewaste

water supply

8" (20.3 cm) min. bend

radius from valve

Keep drain hose straight as shown.

10