Frymaster BIGLA30 warranty Filter Busy

Page 70

5.4.5 Filter Busy

When FILTER BUSY is displayed the MIB board is waiting on another vat to be filtered or waiting on another issue to clear. Wait 15 minutes to see if problem is corrected. If not, call your local ASA.

DANGER

Do not drain more than one frypot at a time into the built-in filtration unit to avoid overflow and spillage of hot oil that may cause severe burns, slipping and falling.

WARNING

The filter pump is equipped with a manual reset switch in case the filter motor overheats or an electrical fault occurs. If this switch trips, turn off power to the filter system and allow the pump motor to cool 20 minutes before attempting to reset the switch (see photo below).

WARNING

Use caution and wear appropriate safety equipment when resetting the filter pump reset switch. Resetting the switch must be accomplished with care to avoid the possibility of a serious burn from careless maneuvering around the drain tube and frypot.

Filter Pump Reset Switch

5.5Manual or End of Day Filtration (MAINT FLTR)

NOTICE

The filter pad or paper must be replaced daily.

DANGER

Do not drain more than one frypot at a time into the built-in filtration unit to avoid overflow and spillage of hot oil that may cause severe burns, slipping and falling.

Ensure that the filter pad or paper is replaced daily to keep the system operating correctly.

1.The fryer MUST be at setpoint temperature. With the computer On press and hold the FLTR button for three seconds.

5-8

Image 70
Contents Manufactured Canada Page LOV GAS Warranty Statement Parts Return Safety Information GeneralComputer Information for the M3000 Computers Installation, Operating, and Service PersonnelEuropean Community CE Specific Information Qualified Service Personnel Qualified Installation PersonnelQualified AND/OR Authorized Operating Personnel Retain and Store this Manual in a Safe Place for Future USE General Installation Requirements Clearance and VentilationNational Code Requirements Electrical Grounding RequirementsCaster Installation Non-CE Standard For Incoming Gas Pressures Gas Connection Pipe Sizes CE Standard Converting to Another Gas Type Single Dual Gas VatCE Gas Conversion Kits for Units with Gas Valve Non-CE Gas Conversion KitsNon-CE Gas Conversion Kits for Australia CE GAS Conversion InstructionsAfter Fryers are Positioned at the Frying Station Typical Configuration BIGLA330 Shown BIGLA30 Series GEN II LOV GAS Fryer Operating InstructionsPage Press the computer ON/OFF switch to the OFF position Lighting the FryerShutdown OperationPrepare the System for Use Low Oil Volume Automatic RefillInstall the JIB Changing the JIBFront of the fryer off see Figure FR Fries M3000 General InformationBasic Operation Cooking with Multi-Product Display Cooking with Dedicated Display Changing from Breakfast Setup to Lunch Changing from Lunch Setup to Breakfast Navigation Buttons Filter, Temperature and Info ButtonsM3000 Button Description and Functions Cook Channel and Selection ButtonsM3000 Menu Summary Tree Draining, Refilling, and Disposing of OilFryer Setup Mode Programming 123424hR Escape Menu Items 10 M3000 Common TasksFull Product Adding New Product Items to the Menu Product SelectionSelection ProdCook ID Disable Product selection prompt Storing Menu Items in Product ButtonsTo Level 1 program changing to the Product selection Draining and Refilling Vats, and Disposing of Oil Disposal for Non-Bulk Oil SystemsDraining and Disposing Oil using Bulk Oil Systems Refilling JIB Oil SystemsPage Accessing the Filter Menu Refilling the Vat from Bulk Oil Systems after DisposalDrain to Pan Fill Vat from Drain Pan Yes noFill Vat from Bulk Programming Level One Pan to WasteAIF Clock Deep Clean Mode BOIL-OUT Selection displayPAN EMPTY? and Yes noPage HIGH-LIMIT Test Mode Programming Level Two CompProduct Comp Mode Level 2 ProgramLOG Mode Password Setup ModeAlert Tone Mode Filter After Info Mode Filter TimeFull VAT Configuration Filter Stats ModeSplit VAT Configuration Review Usage Mode DAY wed, Date 03/20/07 Current day and dateFull / Split VAT Configuration Last Load Mode4321 Page BIGLA30 Series GEN II LOV GAS Fryer Filtration Instructions IntroductionDo not USE Filter Powder with the PAD DRAINING, Washing and Filling during the process Auto Demand FiltrationPage Clogged Drain Error Normal Operation Resumes Filter Error FlowchartSystem Error FIXED? YES no is displayedClogged Drain or Oil Sensor Fail Flowchart Filter Busy Page Page Inspect Fryer and Accessories for Damage Fryer Preventive Maintenance Checks and ServiceDaily Checks and Service Clean Fryer Cabinet Inside and Out DailyDeep Clean Boiling Out the Frypot Weekly Checks and Service 6.3.1 Clean Behind FryersCleaning the Frypot Quarterly Clean Filter Pan, Detachable Parts and AccessoriesClean Combustion Air Blower Assembly BI-WEEKLY Checks and ServiceQuarterly Checks and Service Check M3000 Computer Set Point AccuracyLeft Viewing PortRight Port is Behind Motor Annual/Periodic System Inspection Clean Oil Level SensorReplace the O-RINGS FryerBuilt-In Filtration System BIGLA30 Series GEN II LOV GAS Fryer Operator Troubleshooting Change Filter Service Auto Top Off Problems Probable Causes Corrective Action Problem ExplanationError Drain Valve not Closed Bulk Oil Systems Used oil to a JIBService Hotline
Related manuals
Manual 88 pages 5.79 Kb Manual 26 pages 13.97 Kb