Jenn-Air JGS8750BD, JGS9900BD, JGS8860BD, JGS8850BD manual Quick Test Mode for EOC

Page 22

Testing Procedures

!WARNING

To avoid risk of electrical shock, personal injury or death; disconnect power and gas to range before servicing, unless testing requires power and/or gas.

"Quick Test" Mode for EOC III

Follow the procedure below to perform the EOC III quick test. Once the control is in the quick test mode, any relay may be activated in any sequence. The test mode will be exited after 10 minutes of inactivity (no pads pressed within 10 minutes).

1.Press the Setup pad, then press the right ATM pad.

2.Press the left ATM pad, then press and hold Back and Enter pads for 5 seconds to enter SERVICE menu options.

3.Press the right ATM pad to scroll to the TEST menu.

4.Press the left ATM pad to select TEST options.

5.Press the left ATM pad again to enter the "Quick Test" mode.

6.Press each of the following pads indicated in the table below.

7.Press Cancel or Setup pads to exit.

NOTE: Press and hold the applicable pad to activate the associated response. Release the applicable pad to deactivate the associated response.

The control automatically enters the engineering mode so visual feedback of relay operations is available on the control display. Any time a load is activated, the cooling fan is activated. When the load is deactivated, the cooling fan is also deactivated.

Display will indicate the following:

Pad

Response

BAKE

Bake relay activated.

 

BROIL

Broil relay activated.

CONVECT

Convection Bake and Cooling Fan relays activated.

OVEN LIGHT

Oven light relay activated.

RAPID PREHEAT

Convection Fan (HIGH/LOW) activated.

WARMING ZONE

Warming Zone relay activated.

VENT (DOWNDRAFT) FAN

................Vent Fan relay activated.

CLEAN

Motorized Door Lock relay activated.

SETUP

1 Second Beep.

FAN

Downdraft Fan (HIGH/LOW) relay activated.

WARMING DRAWER

Warming Drawer (HIGH/LOW) relay activated.

Oven Sensor and Meat Probe Resistances

OVEN SENSOR

Sensor Type: RTD 1000 Ω platinum

Calibration: 1654 Ω (350° F/177° C)

 

MEAT PROBE

Type:

NTC Thermistor

Calibration:

9938 Ω (150° F/65.5° C)

Temperature F (C)

Resistance (Ohms)

200 (94)

1350

350 (177)

1654

550 (287)

2047

900 (483)

2697

Temperature F (C)

32(0)

68 (20)

95 (35)

122(50)

158(70)

185(85)

212 (100)

Resistance (Ohms) 163300 62450 32660 18020

8760

5360

3400

22

16026923

© 2006 Maytag Services

Image 22
Contents Service Customer Service Support Center Important InformationTable of Contents Safety Practices for Servicer ServicingUsing the Oven Receiving OvenBaking, Broiling, and Roasting Connecting Range to GasProduct Safety Devices Electrical RequirementsGeneral Information Service SpecificationsPlacement of the Oven Parts and AccessoriesArning GroundingRange Description Troubleshooting Procedures Burner, but burner does not Description of Fault Codes for EOC Control-Related Error not measurableOven Sensor, Meat Probe and Cooling Fan Temperature Charts Gas OFF Illustration Component Test Procedure ResultsGas on Factory set to Natural GasJGS8850BD Pad Illustration Component Test ProcedureControl Component Test Procedure Results Trace MeasurementControl Component Test Procedure Pad Results Pad TraceClock & Day Display Disable Oven Temperature AdjustmentSabbath Mode 208/240 V SettingVolume Feature Access Procedure Tone OptionsTimers Tones Energy Saver ModeRelay Logic for EOC Quick Test Mode for EOC Description of Fault Codes for EOC Top Burner Assembly Removal Select Models Cartridge Assembly Removal Select ModelsMaintop Assembly Removal Select Models Lower Burner Assembly Removal Select ModelsBurner Switch Replacement Spark Module ReplacementManifold Assembly Removal Control Panel Assembly RemovalConvection Element Replacement Select Models Cooling Fan ReplacementOven Sensor Replacement Bake Burner and Ignitor RemovalRegulator Removal Oven Light Bulb/Oven Light Socket ReplacementOven Hi-Limit Thermostat Replacement Gas Valve Removal Select ModelsStorage Drawer Disassembly Oven Door Latch ReplacementStorage Drawer Track Disassembly Select Models Bottom Access Panel Removal Select ModelsWarming Drawer Disassembly Warming Drawer Hi-Limit Switch Replacement Select ModelsWarming Drawer Track Disassembly Select Models Oven Door DisassemblyStorage Drawer and Access Panel Disassembly Oven Door, Warming DrawerAppendix a Jenn-Air Updraft Gas Slide-In Range All Ranges can TIP and Cause Injuries to Persons Electric SupplyElectrical Supply Connection Gas Supply Follow these procedures to remove appliance for servicingCheck Pressure of House Piping System Clearance Dimensions Dégagements Dimensions/Dimensions/Dimensiones Use Lappareil Gas/À gaz/Gas Electric/Électrique/Eléctrica Appendix B USE & Care Guide Surface Controls Operating During a Power FailureSetting the controls Pilotless IgnitionHigh Performance Burner CooktopSealed Burners Low Turn Down BurnerCare and Cleaning Ventilation System Ventilation SystemQuickset Pads Setting the ClockControl Panel ClockTimers Locking the Control and Oven DoorBake Options BakingConvect Convect OptionsConvect Roast Convect BakeRapid Preheat Broil Broiling ChartTo set Broil Cook & Hold DelayMore Options ProofingKeep Warm Meat ProbeFavorites Suggested Internal Food TemperaturesTo select a recipe from the preset Recipe List To Save the Last Recipe CompletedLanguage SetupAuto Convect Conversion Sabbath Mode Temp AdjustTo change the volume of the beeps To adjust the beepsTo change the timer beeps To turn off this featureAppendix C LP Propane Conversion Noir 27A Correct LP Propane Conversion Flip the regulator cap and replace the plastic Reverse steps 6 through To reassemble oven Usted Debe iniciar el enroscado de las30A 31A Correct BON Correcto Gas Conversion Instructions, JGS8850BD*, JGS8860BD Gas Conversion Instructions, JGS9900BD 42mm #5027 a Jaune Correct BON Correcto

JGS9900BD, JGS8860BD, JGS8850BD, JGS8750BD specifications

The Jenn-Air JGS8750BD, JGS8850BD, JGS8860BD, and JGS9900BD are a series of high-performance gas cooktops designed for culinary enthusiasts who value precision and sophistication. These models are distinguished by their robust construction, modern aesthetics, and a range of innovative features that streamline the cooking process.

One of the key features across these models is the professional-grade burners. The JGS8750BD, for instance, boasts a powerful 20,000 BTU burner, perfect for high-heat searing and rapid boiling. In contrast, the JGS8850BD offers a versatile 15,000 BTU burner, catering to a variety of cooking needs, including simmering and sautéing. For more delicate tasks, the JGS8860BD showcases a 5,000 BTU burner designed for simmering sauces and cooking delicate dishes with precision.

Another notable characteristic of these cooktops is the incorporation of the Jenn-Air® Turbo Flame™ technology. This feature provides an exceptional level of control, allowing chefs to achieve the desired temperature with accuracy. This technology is particularly valuable for those who require consistent heat for intricate recipes and techniques.

The seamless stainless-steel design not only elevates the appearance of any kitchen but also offers easy cleaning and maintenance. The high-quality grates found on these models are designed for durability and stability, ensuring pots and pans remain securely in place during cooking. Additionally, the continuous surface grates facilitate effortless sliding of cookware from one burner to another.

The JGS9900BD stands out with its advanced electronic ignition system, which ensures that the burners ignite quickly and reliably, minimizing downtime in the kitchen. Safety is also a priority across these models, featuring flame failure detection that automatically shuts off the gas supply if a flame goes out.

In terms of size, these cooktops cater to different kitchen configurations, with varying configurations to suit individual preferences and space constraints. Whether you're an avid home cook or a professional chef, the Jenn-Air JGS8750BD, JGS8850BD, JGS8860BD, and JGS9900BD combine superior technology with elegant design, making them a valuable addition to any modern kitchen. This series exemplifies Jenn-Air's commitment to quality, performance, and aesthetics, ensuring an elevated cooking experience for all users.