Henny Penny 342 manual Filter Switch

	Model OFE/OFG/OEA/OGA-341, 342
2-14. FILTER SWITCH	3. Label and remove the wires from the switch. With test
REPLACEMENT	instrument check across the terminals of the switch. With the
(Continued)	switch in the on position, the circuit should be closed. With the
	switch in the off position, the circuit should be open. If the
	switch is defective, replace by continuing with this
	procedure. Figure 2-35.

Figure 2-35

4.With wires removed from the switch, push in on tabs on the switch and remove switch from front of switch box cover. Figure 2-36.

5.Push new switch into panel and reconnect wires.

Figure 2-36

2-15. GAS CONTROL VALVE The gas valve assembly controls the flow of gas to the pilot and the

REPLACEMENT main burner. The valve has two 24-volt coils, which are regulated by the P and M terminals on the valve. The C terminal is the common terminal. For gas flow to the pilot, 24 VAC must be present between the P and C terminals. For gas flow to the main burner, 24 VAC must be present between the M and C terminals.

TO AVOID PERSONAL INJURY OR PROPERTY

DAMAGE, BEFORE STARTING THIS

PROCEDURE, MOVE THE MAIN POWER SWITCH

TO THE OFF POSITION. DISCONNECT THE MAIN

CIRCUIT BREAKERS AT THE CIRCUIT BREAKER

BOX OR UNPLUG SERVICE CORD FROM WALL

RECEPTACLE. TURN OFF THE MAIN GAS

SUPPLY TO THE FRYER AND DISCONNECT AND

CAP THE MAIN SUPPLY LINE TO FRYER, OR

POSSIBLE EXPLOSION COULD RESULT.

1003 2-13