Henny Penny 342 manual To avoid electrical shock or property damage, move

Page 9

Model OFE/OFG/OEA/OGA-341, 342

2-9. IGNITION MODULE During normal operation, the ignition modules send 24 volts to the ignitors and gas valve. If a module does not sense a pilot flame, the module starts the ignition process again. But, if a pilot light goes out for longer that 10 seconds, or it goes out 3 times within 10 seconds, the module keeps the 24 volts from reaching the gas valve. The burners shut down.

1. Remove electrical power supplied to the unit.

 

To avoid electrical shock or property damage, move the

 

power switch to OFF and disconnect main circuit

 

breaker, or unplug cord at wall receptacle.

Figure 2-23

2. Remove the control panel and heat shield from control area.

 

Figure 2-23.

3.Using a 3/8 inch socket, remove the two nuts securing the module. Figure 2-24.

Figure 2-24

4.Label and remove the wires at module. Figure 2-25.

5.Install new module in reverse order.

Figure 2-25

1003

2-9

Image 9
Contents High Temperature Limit Control Maintenance HintsIntroduction Gas UnitsRemove the high limit from bracket Remove the two screws securing the high limit to the bracketWires and terminals. The tube must never be in such a Capillary line under and away from all electrical powerPosition where it could accidentally touch the electrical Power terminalsPower Switch Power Switch Excess force will damage probe Flame SENSOR/ Pilot / Ignitor Assembly GAS Temperature Probe Replacement ElectricFlame SENSOR/ Pilot / Ignitor Assembly Gas Remove the control panel and heat shield from control area Replacement Boards ReplacementTransformer To avoid property damage, do not tamper with, or disassemble Filter Switch Replacement Filter Switch GAS Control Valve Remove screws securing the rear cover to the unit Blower Motor Replacement Heating Elements Electric Blower Motor ReplacementWire Nos Voltage Wattage Ohms cold Heating Checkout Power RemovedContactors 30 31 34 35 36 FigureRe-apply power to unit and turn power switch to on Heating Contactors Electric Replacement Primary ContactorSpeaker Assembly 106 High Temperature Connect the two electrical wiresLimit Control Electric Where it could accidentally touch the electrical power Line under and away from all electrical power wiresTerminals. The tube must never be in such a position TerminalsMotor Removal Transformer Replacement Filter Pump and Motor RemovalAutolift If applicable Actuator Motor ReplacementAutolift Actuator Motor Replacement Install new actuator in reverse order