Henny Penny 342 manual Autolift Actuator Motor Replacement

Page 29

Model OFE/OFG/OEA/OGA-341, 342

2-24. AUTOLIFT ACTUATOR (MOTOR) REPLACEMENT

(if applicable)

5. Disconnect actuator connector. Figure 2-80.

Figure 2-80

6. Remove female connector from plate. Figure 2-81.

Figure 2-81

Figure 2-82

7. Using 7/16” socket, remove the 4 nuts securing the support

 

plate. 2 nuts are behind the insulation. Figures 2-82 & 2-83.

Figure 2-83

1003

2-29

Image 29
Contents High Temperature Limit Control Maintenance HintsIntroduction Gas UnitsRemove the high limit from bracket Remove the two screws securing the high limit to the bracketWires and terminals. The tube must never be in such a Capillary line under and away from all electrical powerPosition where it could accidentally touch the electrical Power terminalsPower Switch Power Switch Excess force will damage probe Flame SENSOR/ Pilot / Ignitor Assembly GAS Temperature Probe Replacement ElectricFlame SENSOR/ Pilot / Ignitor Assembly Gas Remove the control panel and heat shield from control area Transformer ReplacementBoards Replacement To avoid property damage, do not tamper with, or disassemble Filter Switch Replacement Filter Switch GAS Control Valve Remove screws securing the rear cover to the unit Blower Motor Replacement Heating Elements Electric Blower Motor ReplacementWire Nos Voltage Wattage Ohms cold Heating Checkout Power RemovedContactors 30 31 34 35 36 FigureRe-apply power to unit and turn power switch to on Heating Contactors Electric Replacement Primary ContactorSpeaker Assembly 106 Limit Control Electric High TemperatureConnect the two electrical wires Where it could accidentally touch the electrical power Line under and away from all electrical power wiresTerminals. The tube must never be in such a position TerminalsMotor Removal Autolift Transformer ReplacementFilter Pump and Motor Removal If applicable Actuator Motor ReplacementAutolift Actuator Motor Replacement Install new actuator in reverse order