Hoshizaki DCM-750BAH-OS, DCM-750BWH-OS service manual Control Board

Page 14

D. Control Board

•A Hoshizaki exclusive solid-state control board is employed in DCM-750BAH, DCM‑750BAH-OS, DCM-750BWH, and DCM‑750BWH‑OS Cubelet Icemaker / Dispensers.

•All models are pretested and factory-adjusted.

CAUTION

1.Fragile, handle very carefully.

2.The control board contains integrated circuits, which are susceptible to failure due to static discharge. It is especially important to touch the metal part of the unit before handling or replacing the board.

3.Do not touch the electronic devices on the control board or the back of the control board to prevent damage to the control board.

4.Do not change wiring and connections. Especially, never misconnect terminals.

5.Always replace the whole control board if it goes bad.

6.Do not short out power supply to test for voltage.

14

Image 14

Contents DCM-750BAH DCM-750BAH-OS DCM-750BWH DCM-750BWH-OS Hoshizaki AMERICA, INC Contents Page Specifications Icemaker DCM-750BAHDCM-750BAH-OS Water TEMP. FDCM-750BWH Potable Water WATER-COOLED CondenserDCM-750BWH-OS Potable Water Water Cooled CondenserII. General Information Construction DCM-750BWH-OS Ice Making Unit Sequence of Operation Startup Control Board Control Board Layout DCM-750BAH, DCM-750BWH Control BoardDCM-750BAH-OS, DCM-750BWH-OS Features LED LightsPower Supply Controls and Adjustments Portion ControlControl Board Check Procedure Ice Making ComponentsDispensing Components DCM-750BAH, DCM-750BWH Float Switch Inlet Water Valve DCM-750BWH-OS Wiring Diagrams Wire Color CodeDCM-750BAH-OS, DCM-750BWH-OS Sequence of Electrical Circuit Ice Making DCM-750BWH-OSIce Purge Cycle Orange WHITE/BLACK Pink WHITE/BROWN RED WHITE/BLUE Violet Hour Drain Cycle / Drain Switch Shutdown Low Water Safety High Pressure Switch Sequence of Electrical Circuit Dispensing Continuous DispensePortion Dispense Performance Data 192Approximate IV. Service Diagnosis Diagnostic Procedure Ice Production Check Diagnostic Charts No Ice ProductionProblem Possible Cause Remedy Problem Possible Cause Remedy Low Ice Production Other Dispensing Opti Serve OS Sensors 5c. Water Dispensing 5a. Ice Dispensing Continuous Mode5b. Ice Dispensing Portion Mode Refrigerant Recovery Removal and Replacement of ComponentsService for Refrigerant Lines BrazingEvacuation and Recharge R-404A Removal and Replacement of Compressor Removal and Replacement of Expansion Valve Removal and Replacement of Evaporator Assembly Components Removal and Replacement of Extruding Head Upper Bearing Wear CheckRemoval and Replacement of Auger Removal and Replacement of EvaporatorPage 5b. Lower Housing Removal and Replacement of Gear Motor Page Removal and Replacement of Water-Cooled Condenser Page Adjustment of Water Regulating Valve Water-Cooled Model Only Removal and Replacement of Fan MotorRemoval and Replacement of Inlet or Dispensing Water Valve Removal and Replacement of Drain ValveDispensing or Agitating Motor Removal and Replacement of Dispensing SystemDispensing Auger and Agitator Page VI. Cleaning and Maintenance Cleaning and Sanitizing InstructionsCleaning Solution Water SystemSanitizing Solution Dispensing ComponentsBin Control Bracket Snap Pin Maintenance Frequency Area TaskPreparing the Icemaker for Long Storage