Hoshizaki DCM-750BAH-OS, DCM-750BWH-OS service manual

Page 69

2.On water-cooled model only, remove the water from the water-cooled condenser:

1)Make sure the control switch and the power switch are in the "OFF" position and that the power supply is off. Remove the top, apron, and left side panels.

2)Close the condenser water supply line shut-off valve and open the condenser water supply line drain valve.

3)Attach a compressed air or carbon dioxide supply to the condenser water supply line drain valve.

4)Open the water regulating valve by using a screwdriver to pry up on the spring retainer underneath the spring. While holding the valve open, blow out the condenser using the compressed air or carbon dioxide supply until water stops coming out.

5)Close the condenser water supply line drain valve.

6)Replace the panels in their correct positions.

69

Image 69
Contents DCM-750BAH DCM-750BAH-OS DCM-750BWH DCM-750BWH-OS Hoshizaki AMERICA, INC Contents Page DCM-750BAH Specifications IcemakerWater TEMP. F DCM-750BAH-OSPotable Water WATER-COOLED Condenser DCM-750BWHPotable Water Water Cooled Condenser DCM-750BWH-OSII. General Information Construction DCM-750BWH-OS Ice Making Unit Sequence of Operation Startup Control Board Control Board Control Board Layout DCM-750BAH, DCM-750BWHDCM-750BAH-OS, DCM-750BWH-OS LED Lights FeaturesControl Board Check Procedure Controls and Adjustments Portion ControlPower Supply Ice Making ComponentsDispensing Components DCM-750BAH, DCM-750BWH Float Switch Inlet Water Valve DCM-750BWH-OS Wire Color Code Wiring DiagramsDCM-750BAH-OS, DCM-750BWH-OS DCM-750BWH-OS Sequence of Electrical Circuit Ice MakingIce Purge Cycle Orange WHITE/BLACK Pink WHITE/BROWN RED WHITE/BLUE Violet Hour Drain Cycle / Drain Switch Shutdown Low Water Safety High Pressure Switch Continuous Dispense Sequence of Electrical Circuit DispensingPortion Dispense 192 Performance DataApproximate IV. Service Diagnosis Diagnostic Procedure Ice Production Check No Ice Production Diagnostic ChartsProblem Possible Cause Remedy Problem Possible Cause Remedy Low Ice Production Other Dispensing Opti Serve OS Sensors 5a. Ice Dispensing Continuous Mode 5b. Ice Dispensing Portion Mode5c. Water Dispensing Service for Refrigerant Lines Removal and Replacement of ComponentsRefrigerant Recovery BrazingEvacuation and Recharge R-404A Removal and Replacement of Compressor Removal and Replacement of Expansion Valve Removal and Replacement of Evaporator Assembly Components Upper Bearing Wear Check Removal and Replacement of Extruding HeadRemoval and Replacement of Evaporator Removal and Replacement of AugerPage 5b. Lower Housing Removal and Replacement of Gear Motor Page Removal and Replacement of Water-Cooled Condenser Page Removal and Replacement of Fan Motor Adjustment of Water Regulating Valve Water-Cooled Model OnlyRemoval and Replacement of Drain Valve Removal and Replacement of Inlet or Dispensing Water ValveRemoval and Replacement of Dispensing System Dispensing Auger and AgitatorDispensing or Agitating Motor Page Cleaning and Sanitizing Instructions VI. Cleaning and MaintenanceWater System Cleaning SolutionDispensing Components Sanitizing SolutionBin Control Bracket Snap Pin Frequency Area Task MaintenancePreparing the Icemaker for Long Storage