3)Remove the front cover of the storage bin.
4)Remove the motor bracket thumbscrews, first from the vertical plane and then from the horizontal plane. While holding on to the corresponding agitator or auger, move the agitating motor or the dispensing motor towards you. Remove the agitators and the dispensing auger from the storage bin. See Fig. 6.
5)Remove the bin control assembly. See Fig. 7.
6)Remove the snap pin, shaft, and actuator.
7)Remove spout B, spout A, and their gaskets.
8)Remove the spout cover, ice dispensing spout, and water dispensing nozzle. See
Fig. 8. Also remove the ice guide, drain pipe holder, and drain pipe from the storage bin.
9)Immerse the agitator, dispensing auger, and parts removed in steps 5 through 8 in the cleaning solution and then in the sanitizing solution for about 15 minutes each. Rinse the parts thoroughly with clean water.
10)Wipe the shutter located above the ice dispensing spout thoroughly with a clean cloth.
11)Reassemble the bin control assembly and replace all parts in the reverse order of which they were removed.
12)Pour warm water into the storage bin and melt any remaining ice. Clean the storage bin liner and the front cover of the storage bin using a neutral cleaner. Rinse thoroughly after cleaning. Replace the front cover of the storage bin in its correct position.
13)Move the power switch to the "ON" position and replace the panels in their correct positions. Turn on the power supply, then move the control switch to the "ICE" position to start the automatic icemaking process.
Bin Control Bracket
Snap Pin
| Water Dispensing Nozzle |
Shaft |
|
| Ice Dispensing Spout |
Actuator | Spout Cover |
Fig. 7
Fig. 8
66