18)Move the power switch to the "ON" position, then replace the panels in their correct positions.
19)Turn on the power supply, then move the control switch to the "ICE" position to start the automatic icemaking process.
6.Removal and Replacement of Gear Motor
1)Move the control switch to the "DRAIN" position and drain all of the water from the evaporator.
2)After the water has stopped draining, move the control switch to the "OFF" position, then turn off the power supply. Remove the front and top panels, then move the power switch to the "OFF" position.
3)Remove the front cover of the storage bin. Remove spout B, then remove spout A. See Fig. 1.
4)Remove the apron panel, then remove the left side panel.
5)Remove the evaporator strap.
6)Remove the evaporator assembly bolts securing the evaporator assembly to the gear motor. Lift the evaporator assembly up slightly. See Fig. 3.
7)Disconnect the wiring from the gear motor, then remove the
gear motor bolts. Lift the gear motor from the drain pan.
8) Place the new gear motor in the drain pan.
9) Using the gear motor bolts and washers, secure the gear motor.
10)Connect the gear motor wires.
11)Lower the evaporator assembly down and secure it to the gear motor.
12)Replace the evaporator strap in its correct position.
13) | Replace spout A, spout B, and the front | Evaporator |
|
|
| ||
| cover of the storage bin in their correct | Evaporator |
|
| positions. |
| |
| Assembly |
| |
|
|
| |
14) | Move the power switch to the "ON" | Bolts |
|
| position, then replace the panels in their |
|
|
| correct positions. |
| Gear Motor Bolts |
15) | Turn on the power supply, then move the |
| |
Gear Motor |
| ||
| control switch to the "ICE" position to start |
| |
| the automatic icemaking process. |
|
|
|
| Drain Pan | Fig. 3 |
55