Jackson Tempstar GP technical manual Lower WASH, & Rinse ARM Assembly

Page 36

LOWER WASH, & RINSE ARM ASSEMBLY

01

02

03

04

05

06

07

08

09

10

11


	ITEM	QTY	DESCRIPTION	MFG NO.

	01	2	Wash Arm End Plug	5700-011-35-92
	02	2	Rinse Arm End Plug	4730-609-04-00
	03	1	Bulk Head Plug	4730-609-05-00
	04	1	Strainer Weld Assembly	5700-031-50-07
	05	1	Rinse Arm	5700-031-50-63
	06	1	Rinse Manifold Assembly	5700-021-47-61
	07	1	Lower Wash Casting	5700-031-46-01
	08	2	Bolt, 3/8" X 11/4" Long	5305-276-10-00
	09	1	Wash Arm	5700-021-35-93
	10	1	Rack Guide Weldment	5700-002-01-01
	11	1	Lower Wash Manifold	5700-002-05-18

34

Image 36

Contents Technical Manual Table of Contents Specifications of the Tempstar GP Installation Instructions GAS Connection Operation Instructions Overview of Operation Overview of Operation Thermostat Adjustment Procedure AUTO-CALIBRATION Procedure Auto CalibrationTesting and Setting the Set Point Temperature Electronics Control Board ECBTesting the Thermistors To test the temperature at the T-in ThermistorControl Board LED Light Indications Green LED is offTroubleshooting Section Symptom Possible Cause ActionTroubleshooting Section Leaks do not USE Flame Low rinse temperature/low wash Low inlet water temperature Polarity will Damage the Circuit Boards DSICombination cutoff valve and the modulating Check ignition wire. Check that lights above Dimensions Table Dimensions Main Assembly Shown Not ShownControl BOX Assembly Front View QTY Description MFG noControl BOX Assembly TOP View Control BOX ASSEMBLY-TOP View Hood Assembly Cantilever ARM Assembly TUB Assembly Back of TUB, & Drain Assembly Lower Assembly Right Side Incoming Plumbing Assembly Incoming Plumbing Parts Lists GAS Pack Assembly Upper WASH, & Rinse ARM Assembly Lower WASH, & Rinse ARM Assembly Steam Coil Assembly Steam Coil Assembly Parts Lists Rinse Tank Assembly Electronic Control Drawer Components RED Green LEDElectrical Diagram 208/240 Volt 60 Hertz 1 Phase