Jackson Tempstar GP technical manual Electronic Control Drawer Components, RED Green LED

Page 40

ELECTRONIC CONTROL DRAWER COMPONENTS

RED		GREEN		1		2		3		4		5		6		7		8		9
LED		LED
LED		LED

ITEM	QTY	DESCRIPTION	MFG NO.

01	1	Electronic Control Drawer Assembly	5700-002-21-10
02	1	Wiring Harness-Thermistor Cable	5700-002-12-34
03	1	Electronic Control Board (ECB)	6680-002-12-26
04	1	Wiring Harness-DSI Cable	5700-002-12-36
05	1	Wiring Harness-Power Supply Cable	5700-002-12-35
06	1	Wiring Harness-Modulating Valve (GP)	5700-002-37-03
07	1	Direct Spark Ignition Board (DSI)	6680-002-12-25
08	1	Ignition Cable	5700-002-12-37
09	1	Circuit Breaker 3 amp	5925-022-36-94

38

Image 40

Contents Technical Manual Table of Contents Specifications of the Tempstar GP Installation Instructions GAS Connection Operation Instructions Overview of Operation Overview of Operation Thermostat Adjustment Procedure AUTO-CALIBRATION Procedure Auto CalibrationTesting and Setting the Set Point Temperature Electronics Control Board ECBTesting the Thermistors To test the temperature at the T-in ThermistorControl Board LED Light Indications Green LED is offTroubleshooting Section Symptom Possible Cause ActionTroubleshooting Section Leaks do not USE Flame Low rinse temperature/low wash Low inlet water temperature Polarity will Damage the Circuit Boards DSICombination cutoff valve and the modulating Check ignition wire. Check that lights above Dimensions Table Dimensions Main Assembly Shown Not ShownControl BOX Assembly Front View QTY Description MFG noControl BOX Assembly TOP View Control BOX ASSEMBLY-TOP View Hood Assembly Cantilever ARM Assembly TUB Assembly Back of TUB, & Drain Assembly Lower Assembly Right Side Incoming Plumbing Assembly Incoming Plumbing Parts Lists GAS Pack Assembly Upper WASH, & Rinse ARM Assembly Lower WASH, & Rinse ARM Assembly Steam Coil Assembly Steam Coil Assembly Parts Lists Rinse Tank Assembly Electronic Control Drawer Components RED Green LEDElectrical Diagram 208/240 Volt 60 Hertz 1 Phase