Installation
WARNING
To avoid electrical shock which can cause severe personal injury or death:
•Disconnect power to refrigerator before reversing doors.
15.Carefully place freezer door on top of hinge arm. Use foam door spacer to set gap.
Reversing Doors
Tools Required:
•Phillips screwdriver
•5⁄16" socket and ratchet
•5⁄16" end wrench
•Putty knife
Unplug the refrigerator.
1.Remove the hinge cap and set aside.
2.Remove screws from the upper hinge with a 5⁄16" socket and ratchet and set aside.
3.Carefully lift and remove freezer door (including the upper hinge) off the center hinge.
4.Remove screw and hinge arm from top of the refrigerator door.
5.Carefully lift and remove refrigerator door.
6.Remove front base grille and set aside.
7.Remove hinge plate from lower corner of refrigerator and secure it on the opposite side.
8.Remove the plate from the underside of the refrigerator door and secure it on the opposite side.
9.Remove the plate from the underside of the freezer door and secure it on the opposite side.
10.Remove the plug button(s) from tops of freezer and refrigerator doors and replace them on the opposite side.
11.Remove screw hole plugs from top of cabinet and replace on the opposite side.
12.Remove washers and stem from the inside of the hinge plate and place them on the outside of the hinge plate.
13.Carefully replace refrigerator door on the hinge plate in lower corner.
14.Slide the hinge arm into place and secure with screw.
Note
•Do not discard the foam door spacer. Doors may settle with use.
16.Slide top hinge into place on freezer door and secure screws with 5⁄16" wrench.
Confirm that all screws have been tightened securely.
17.Snap hinge cap securely in place.
18.Replace front base grille.
Remember to plug in your refrigerator and reset the controls to the appropriate setting(s).
4