GE PT925 manual Using the clock, kitchen timer and control lock, Cleaning Troubleshooting, Safety

Using the clock, kitchen timer and control lock. ge.com

Safety

Make sure the clock is set to the correct time of day.

To Set the Clock

The clock must be set to the correct time of day for the automatic oven timing functions to work properly. The time of day cannot be changed during a timed baking or self-cleaning cycle.

Touch the CLOCK pad.

Touch the number pads.

Touch the START pad.

Instructions

The Kitchen Timer is in hours and minutes.

The Kitchen Timer does not control oven operations. The maximum setting on the Kitchen Timer is 9 hours and 59 minutes.

To Set the Kitchen Timer

Touch the TIMER pad.

Touch the number pads until

the amount of time you want shows in the display. For example, to set

2 hours and 45 minutes, touch 2, 4 and 5 in that order. If you make

a mistake touch the TIMER pad and begin again.

Touch the START pad.

After touching the START pad, SET disappears; this tells you the time is counting down, although the display does not change until one minute has passed. Seconds will not be shown in the display until the last minute is counting down.

When the Kitchen Timer reaches :00, the control will beep 3 times followed by one beep every 6 seconds until the TIMER pad is touched.

The 6-second tone can be canceled by following the steps in the Special features of your oven control section under Tones at the End of a Timed Cycle.

Operating Instructions Care and

To Reset the Kitchen Timer

If the display is still showing the time	If the remaining time is not in the display
remaining, you may change it by touching	(clock, delay start or cooking time are in
the TIMER pad, then touch the number	the display), recall the remaining time by
pads until the time you want appears	touching the TIMER pad and then touching
in the display.	the number pads to enter the new time
	you want.

To Cancel the Kitchen Timer

Touch the TIMER pad twice.

Control Lock

Cleaning Troubleshooting

Your control will allow you to lock out

the touch pads so they cannot be activated when touched.

Press and hold for 3 seconds.

To lock/unlock the controls:

Touch and hold the 9 and 0 pads for 3 seconds.

The oven display will show “Oven controls locked” for several seconds, then “Locked.”

To unlock the control, touch and hold the 9 and 0 pads for 3 seconds.

■The CONTROL LOCK mode affects all touch pads. No touch pads will work when this feature is activated.

Tips Consumer Support

11