Installation Instructions, Install the Cooktop

Installation Instructions

1INSTALL THE COOKTOP

A.Remove the screws on the sides of the cooktop burner box. Use those screws to attach the side mounting brackets.

B.Insert the cooktop centered into the cutout opening. Make sure the front edge of the countertop is parallel to the cooktop.

Check clearances at the front, back and sides.

Cooktop

Secure the hold-down bracket to the cabinet sides with screws.

2 INSTALL PRESSURE REGULATOR

WARNING: Never reuse old flexible connectors. The use of old flexible connectors can cause gas leaks and personal injury. Always use new flexible connectors when installing a gas appliance.

To reduce the possibility of gas leaks, apply teflon tape or a thread compound approved for use with LP or Natural gases to all threaded connections.

A.Screw the regulator onto the burner box bottom pipe connection. Make sure the top of the regulator is facing toward the cabinet front, and the arrow on the back of the regulator points to the cooktop.

		To cooktop
		Rear view
	Pressure	of
	Pressure	regulator
	regulator	regulator
	regulator	(note
		(note
		direction
		of arrow)
		Electrical outlet 12″
	Shut-off	below countertop
	Shut-off
	valve

2INSTALL PRESSURE REGULATOR (cont.)

Burner Box

90º Elbow

OPTION: You can install a 90º elbow (not supplied) onto the gas inlet and route the gas connections to avoid interference when installed over an oven, with a downdraft vent, a warming drawer or other cabinetry features.

B. Complete the connection between the regulator and the shut-off valve.

C. Before testing for leaks, make sure all burner knobs are in the OFF position.

After connecting the cooktop to gas, check

system for leaks with a manometer. If a manometer is not available, turn the gas supply on to the cooktop and use a liquid leak detector at all

joints and connections to check for leaks.

Tighten all connections if necessary to prevent gas leakage in the cooktop or supply line.

WARNING: Do not use a flame to check for leaks.

Disconnect the cooktop and its individual shut-off valve from the gas supply piping system during any pressure testing of that system at test pressures greater than 1/2 psig (3.5 kPa).

Isolate the cooktop from the gas supply piping system by closing its individual shut-off valve during any pressure testing of the gas supply system at test pressures equal to or less than 1/2 psig (3.5 kPa).

3CONNECT ELECTRICAL

•Check to be sure the receptacle is properly grounded.

•Plug in the power cord.