After a few seconds, the Fridge will begin adjusting towards the newly set temperature. This will be reflected in the digital display.
Recommend Temp (Fridge) :
38°F
(or 3°C )
-The temperature of the Freezer, Fridge or Flex Zone may rise when you open the doors too frequently, or if a large amount of warm or hot food is placed inside.
-This may cause the digital display to blink. Once the Freezer and Fridge temperature return to their normal set temperatures, the blinking will stop.
-If the blinking continues, you may need to “reset” the Refrigerator. Try unplugging the appliance, wait for around 10 minutes and then plug the power cord back in.
-If there is a communication error between the Display and Main Controller, the Convertible Display light may blink. If the blinking continues for a long period of time, please contact a Samsung Electronics Service Center.
Using the COLD WATER dispenser
Push the appropriate ice type button to select what you want dispensed.
NO ICE
Select this if you want to turn ice maker off
Using the ice Dispenser
Place a glass underneath the ice dispenser and push gently against the dispenser lever with your glass.
Make sure the glass is in line with
the dispenser to prevent the ice from bouncing out.
Please wait 2 seconds before removing the caution glass under the dispenser to prevent spills.
If the Refrigerator door opens, the Dispenser does not work.
•When Cubed Ice is selected after using
caution | the Crushed Ice feature, a small amount of | |
residual crushed ice might be produced. | ||
|
•After Water Dispenser Installation, press the dispenser arm for at least 2 minutes to remove trapped air from the water line and to fill the water system.
| Do not pull the lever out. You could damage | |
caution | or break the |
|
| lever's spring. | check the |
water level
•To clean
caution the ice bin/ bucket, wash with a mild detergent,
rinse well, and dry thoroughly
it. Do not use
harsh or abrasive cleaners or solvents.
•If ice doesn’t come out, pull out the ice bucket and press the test button located on the right side of ice maker.
•Do not press the test button continuously when the tray is filled with ice or water. Water may overflow or ice may jam the bucket.
•Normal Use
To fill the ice bucket to maximum capacity after installation, follow these steps:
1.Allow your refrigerator to operate and cool down for 24 hours (or 1 full day).
- Waiting 24 hours will allow your ice maker to cool properly.
2.Dispense 4 to 6 ice cubes into the glass.
3.After 8, and then 16 hours, dispense a full glass of ice.
•When you press the Test button, you will hear the refrigerator chime
•The chime sounds automatically again to let you know the ice maker is working well.
02 Operating
Operating _15