Liebherr EWTNes 2956 installation instructions Unscrew the lower hinge

Page 12

REVERSING DOOR HINGES

6.Figure 5: Unscrew the lower hinge (13).

-Remove the washer, stops and bushing (14, 7, 8).

-Remove screw (Q).

-Transfer hinge pin (2) to the opposite side.

-Transfer screw (Q) to the opposite side.

-Turn the stop (7) through 180° and position bushing (8) and washer as shown in the detailed drawing. The flat side of the stop must face forwards.

-Screw on hinge (13) on the new hinge side.

7.Install the door fittings as shown in Figure 5. Insert the plugs (X) as shown in the detailed drawing. Move plug (W) to the opposite side of the lower door.

8.Unscrew the center hinge (10) and cover (11), pull them off to the side and after turning them through 180°, slide them on again on the opposite side and secure them.

9.Place the lower door on the hinge pin (2) at the bottom.

-Swivel in the door.

-Pay special attention to the bushing (12) in the center hinge (10).

-Insert the hinge pin (9).

Figure 5

A delight in freshness

10

WF1051 / EWTNes 2956

Image 12
Contents Installation Instructions Please Read and Follow These Instructions To the Installer Table of Contents Installation Guidelines Cabinet Opening Dimensions Planning InformationWF1051 Figure Side-By-Side WF1051 and RB1400 Figure 130 Planning Information Reversing Door Hinges Fig.A BGENesUnscrew the lower hinge Finally mounting screw M4 Door Opening Angle Figures 7 Fig.D1-2 BGENesInstallation UnpackingSpanner Built-in appliances with a wooden ventilation grille Blocking for Safety Fig.R BGENesDo not install the shut-off valve behind the appliance IcemakerWater Connection Figure Connection to the Water Supply Solenoid valve is located at the rear of your unitIcemaker SIDE-BY-SIDE Installation Installation with SBS Ventilation Grille SetCa.210 Spanner Fig.Q BGENes 31 Connect the appliances Fig.S BGENesSpanner At least 31 square inches 200cm2 per unit SIDE-BY-SIDE Installation