SIDE-BY-SIDE Installation

Unpacking

Unpack the side by side installation kit and check with the provided parts list if all parts are included. The part numbers given in the parts list are identical to the numbers in the respective ﬁgures.

For installation you will need the following tools:

Included:

-Star Key Torx® 15

-Star Key Torx® 20

-Star Key Torx® 25

-Socket Wrench 8 mm

-Open-end Wrench 10 mm

Not in package:

-Phillips (star) screwdriver

-Level

-Ruler

Figure 25: To install the WF1051 and RB1400 appliances side-by-side, proceed as follows:

-Always place the WF1051 and RB1400 with the hinges on the left-hand side (looking from the front).

Installation with SBS Ventilation Grille Set:

1.Affix the spacer (1) on the side wall of the appliance – remove the protective film.

2.Push the appliances together,

-align them parallel to each other.

3.Use a level on the top to align them to the same height:

4.Use the open-end wrench 10 mm (3) to adjust the feet at the front of the roller base. Turn clockwise for up and counterclockwise for down. For the rear, turn the adjusting bolt (2) clockwise down and counterclockwise up.

Figure 25

A delight in freshness

20	WF1051 / EWTNes 2956