REVERSING DOOR HINGES
10.Figure 6: Lift up cover (3) on handle side, push outward; lift up cover (1) on hinge side and pull off.
11.Unscrew mounting plate (21): first mounting screw (20), then inner retaining screw (25).
-Unscrew hinge (4): first remove the mounting screw (20), then retaining screws (25). Fit hinge (4) to opposite side: for easy assembly, fit hinge from above and first tighten with the upper retaining screw (25) M5, then screw
(25)and finally mounting screw M4 (20).
-Turn mounting plate (21) through 180° and screw tight again on the new handle side: first retaining screw (25), then mounting screw
12.Transfer hinge pin and screw to the respective opposite side of the hinge (4), but do not insert them in the hole or fasten them now.
13.On the upper door, install the door fittings as shown in Figure 6. Insert the plugs (X) as shown in the detailed drawing. Move plug (W) to the opposite side of the door.
14.Place the upper door on the center hinge, fit the bushing (8), stop (7) and washer on the door, swivel in the door at the top and insert and secure the hinge pin (2) from above through the hinge and stop. Insert screw (6) for fixing the opening angle to 130°.
Check for proper alignment of all doors. Adjust them if necessary using the slots on the hinge.
W
Figure 6
A delight in freshness
WF1051 / EWTNes 2956 | 11 |