Liebherr EWTNes 2956 installation instructions Planning Information, Cabinet Opening Dimensions

Page 6

PLANNING INFORMATION

Cabinet Opening Dimensions -

Figure 1

Allow units to open a minimum of 90° to prevent problems removing drawers. With the door opening 90°, you may have to move drawers slightly to clear the door interior.

Refer to the minimum door clearances in the Pre-

Installation Specifications chart.

• Allow for a minimum 3-3/4" (95 mm) filler, for corner installations, so the door can open to 90°. If you’re using raised panels, consider using a wider filler.

IMPORTANT

Refer to the full scale illustrations at the end of this section for specifics on door openings and filler size alternatives.

"

"

3"" (76mm)

"

" "

Figure 1

A delight in freshness

4

WF1051 / EWTNes 2956

Image 6
Contents Installation Instructions Please Read and Follow These Instructions To the Installer Table of Contents Installation Guidelines Cabinet Opening Dimensions Planning InformationWF1051 Figure Side-By-Side WF1051 and RB1400 Figure 130 Planning Information Reversing Door Hinges Fig.A BGENesUnscrew the lower hinge Finally mounting screw M4 Door Opening Angle Figures 7 Fig.D1-2 BGENesInstallation UnpackingSpanner Built-in appliances with a wooden ventilation grille Blocking for Safety Fig.R BGENesDo not install the shut-off valve behind the appliance IcemakerWater Connection Figure Connection to the Water Supply Solenoid valve is located at the rear of your unitIcemaker SIDE-BY-SIDE Installation Installation with SBS Ventilation Grille SetCa.210 Spanner Fig.Q BGENes 31 Connect the appliances Fig.S BGENesSpanner At least 31 square inches 200cm2 per unit SIDE-BY-SIDE Installation