Liebherr EWTNes 2956 installation instructions Ca.210

Page 23

SIDE-BY-SIDE INSTALLATION

5.Figure 26: Secure the installation frame (3) at the top to the appliances with screws (2).

-Align the appliance at the front bottom.

-Use the predrilled holes to align the installa- tion frame (2).

-First mount the installation (3) frame with 4 screws (2) to one appliance, then align the other appliance with the predrilled holes to the installation frame (3) and secure it with the screws (2).

6.Figure 26: Position the attachment brackets (6) at the rear of the appliances at the top and bottom. Slide the upper attachment bracket upwards as far as possible. Secure it at the side using the screws provided (5). Do not overtighten!

5.2

3

6.

6	5
6.
	5
ca.210	6
ca.210
Figure 26

A delight in freshness

WF1051 / EWTNes 2956

21

Image 23

Contents Installation Instructions Please Read and Follow These Instructions To the Installer Table of Contents Installation Guidelines Planning Information Cabinet Opening DimensionsWF1051 Figure Side-By-Side WF1051 and RB1400 Figure 130 Planning Information Fig.A BGENes Reversing Door HingesUnscrew the lower hinge Finally mounting screw M4 Fig.D1-2 BGENes Door Opening Angle Figures 7Unpacking InstallationSpanner Built-in appliances with a wooden ventilation grille Fig.R BGENes Blocking for SafetyWater Connection Figure Do not install the shut-off valve behind the applianceIcemaker Solenoid valve is located at the rear of your unit Connection to the Water SupplyIcemaker Installation with SBS Ventilation Grille Set SIDE-BY-SIDE InstallationCa.210 Spanner Fig.Q BGENes Fig.S BGENes 31 Connect the appliancesSpanner At least 31 square inches 200cm2 per unit SIDE-BY-SIDE Installation