Liebherr EWTNes 2956 installation instructions At least 31 square inches 200cm2 per unit

Page 28

SIDE-BY-SIDE INSTALLATION

1.For built-in appliances without ventilation grilles and only with installation frame (2), ventilation must take place through the ventilation duct at the rear of the cabinet. Ensure that the ventilation cross-section is at least 31 square inches (200 cm²) per appliance. At least 62 square inches (400 cm²) for side- by-side installation of two appliances. Built-in appliances with an installation frame:

-Figure 33: Screw the installation frame (2) to the appliance through the attachment brackets.

	1		1/2”
38
(		mm)

At least 31 square inches (200cm2) per unit

								”
							/4		)
						3			)
				0				m
				2				m
			”				7
			”			2
		/4			5
		/4		(
	3			)
0			m
2			m
		7
	2
5
(

1.

2

6

Figure 33

A delight in freshness

26	WF1051 / EWTNes 2956

Image 28

Contents Installation Instructions Please Read and Follow These Instructions To the Installer Table of Contents Installation Guidelines Cabinet Opening Dimensions Planning InformationWF1051 Figure Side-By-Side WF1051 and RB1400 Figure 130 Planning Information Reversing Door Hinges Fig.A BGENesUnscrew the lower hinge Finally mounting screw M4 Door Opening Angle Figures 7 Fig.D1-2 BGENesInstallation UnpackingSpanner Built-in appliances with a wooden ventilation grille Blocking for Safety Fig.R BGENesIcemaker Do not install the shut-off valve behind the applianceWater Connection Figure Connection to the Water Supply Solenoid valve is located at the rear of your unitIcemaker SIDE-BY-SIDE Installation Installation with SBS Ventilation Grille SetCa.210 Spanner Fig.Q BGENes 31 Connect the appliances Fig.S BGENesSpanner At least 31 square inches 200cm2 per unit SIDE-BY-SIDE Installation