Liebherr EWTNes 2956 Built-in appliances with a wooden ventilation grille

INSTALLATION

The following ventilation cross-section and distances must be observed:

-There must be a ventilation space of at least 31 square inches (200 cm²) per appliance in the cabinet plinth and under the cabinet top panel.

-The depth of the ventilation duct at the rear of the cabinet must be at least 1- 1/2" (38 mm).

Alternatively:

1.For built-in appliances without ventilation grilles and only with an installation frame, ventilation must take place through the ventilation duct at the rear of the cabinet.

Built-in appliances with an installation frame:

•Figure 19:

-Screw the complete installation frame (2) to the appliance.

(	1		1/2
38			”
		mm)

At least 31 square inches (200cm2)

			”
		/4			)
	3			m
0
2			m
		7
	2
5
(

1.

2

1

2.Built-in appliances with a wooden ventilation grille:

Figure 20: Cut out the wooden trim for use as a ventilation grille using the enclosed template.

-The required ventilation cross-section must be at least 31 square inches

(200 cm²) when a single appliance is installed, which corresponds to template “small” (If you install two appliances side-byside, the cross-section must be at least 62 square inches, (400 cm²), which corresponds to template “double-size;” for more information see “Side-by-Side

Installation”).

•Remove the attachment bracket (2) from the installation frame and screw it to the appliance (1) from underneath. Place the wooden ventilation grille (5) on the appliance, align it in the center and secure it from the rear using the attachment bracket (2).

Figure 19

2	1/2"
5
	(13 mm)
1
24"
(609.6 mm)
3-11/16"
(93,7 mm)

Figure 20

A delight in freshness

WF1051 / EWTNes 2956 15