Liebherr EWTNes 2956 installation instructions Installation, Unpacking

Page 15

INSTALLATION

Only install the winecooler/freezer in a stable kitchen cabinet that has been properly aligned.

-Mount and fix the handles, depending on your model and choice.

Unpacking

Unpack the installation kit and check with the pro- vided parts list if all parts are included.

The part numbers given in the parts list are identical to the numbers in the respective figures.

For installation you will need the following tools:

Included:

-Star Key Torx® 15

-Star Key Torx® 20

-Star Key Torx® 25

-Socket Wrench 8 mm

-Open-end Wrench 10 mm

Not in package:

-Phillips (star) screwdriver

-Level

-Ruler

Figure 16: Installation with Ventilation Grille Set:

1.Screw the installation frame at the top (1) onto the appliance (2).

2.Place the ventilation grille (3) on this, align it in the center and secure at the front from underneath.

3.Slide brackets (4) onto the side installation frames (5) from above and below.

4.Using the frame (5), screw the brackets onto the side wall*.

5.Slide the side installation frames (5) upwards until they are in contact with the underside of the ventilation grille.

6.Secure the side frames with the adhesive section (7) to prevent them from sliding down. Remove the protective film and affix the adhesive sections over the upper brackets on the handle and hinge sides.

1. 2

1

2.

3

 

 

 

 

 

 

 

4

 

6

 

 

 

 

4

3.

 

 

 

5

 

5

 

 

6

4

5

8

 

 

 

 

 

6

 

 

 

 

4

 

 

 

 

4.

6

4

5

 

 

6

4

5.

7 6.

7

7

6.

7

Fig.E BGENes

Figure 16

A delight in freshness

WF1051 / EWTNes 2956

13

Image 15
Contents Installation Instructions Please Read and Follow These Instructions To the Installer Table of Contents Installation Guidelines Planning Information Cabinet Opening DimensionsWF1051 Figure Side-By-Side WF1051 and RB1400 Figure 130 Planning Information Fig.A BGENes Reversing Door HingesUnscrew the lower hinge Finally mounting screw M4 Fig.D1-2 BGENes Door Opening Angle Figures 7Unpacking InstallationSpanner Built-in appliances with a wooden ventilation grille Fig.R BGENes Blocking for SafetyDo not install the shut-off valve behind the appliance IcemakerWater Connection Figure Solenoid valve is located at the rear of your unit Connection to the Water SupplyIcemaker Installation with SBS Ventilation Grille Set SIDE-BY-SIDE InstallationCa.210 Spanner Fig.Q BGENes Fig.S BGENes 31 Connect the appliancesSpanner At least 31 square inches 200cm2 per unit SIDE-BY-SIDE Installation