Liebherr EWTNes 2956 installation instructions SIDE-BY-SIDE Installation

Page 29

SIDE-BY-SIDE INSTALLATION

Built-in appliances with a wooden ventilation grille:

2.Figure 34: Cut out the wooden trim for use as a ventilation grille using the attached template.

-The required ventilation cross-section must be at least 62 square inches (400 cm²) for side-by-side installation of two appliances, which corresponds to the attached template “double-size.”

2.

-Remove the attachment brackets from the installation frame (2) and screw them to the appliance from underneath.

-Place the wooden ventilation grille (5) on the appliance, align it in the center and secure it from the rear using the attachment brackets.

 

1/2"

5

(13 mm)

 

48" (1219,2 mm)

3-11/16"

(93,7 mm)

X

Figure 34

A delight in freshness

WF1051 / EWTNes 2956

27

Image 29
Contents Installation Instructions Please Read and Follow These Instructions To the Installer Table of Contents Installation Guidelines Planning Information Cabinet Opening DimensionsWF1051 Figure Side-By-Side WF1051 and RB1400 Figure 130 Planning Information Fig.A BGENes Reversing Door HingesUnscrew the lower hinge Finally mounting screw M4 Fig.D1-2 BGENes Door Opening Angle Figures 7Unpacking InstallationSpanner Built-in appliances with a wooden ventilation grille Fig.R BGENes Blocking for SafetyWater Connection Figure Do not install the shut-off valve behind the applianceIcemaker Solenoid valve is located at the rear of your unit Connection to the Water SupplyIcemaker Installation with SBS Ventilation Grille Set SIDE-BY-SIDE InstallationCa.210 Spanner Fig.Q BGENes Fig.S BGENes 31 Connect the appliancesSpanner At least 31 square inches 200cm2 per unit SIDE-BY-SIDE Installation