Liebherr EWTNes 2956 installation instructions Fig.Q BGENes

Page 25

SIDE-BY-SIDE INSTALLATION

10.Figure 28: Slide the side installation frames (15) upward until they are in contact with the underside of the ventilation grille, Figure 28.

11.Secure the side frames with the adhesive section (17) to prevent them from sliding down. Remove the protective film and place the adhesive sections over the upper brackets.

12.Figure 29: Install anti-tip brackets for each appliance. Refer to “Blocking For Safety.”

10.

17

15

17

11.

15

11.

17

Fig.Q BGENes

1

2

Figure 28

3

Fig.R BGENes

Figure 29

A delight in freshness

WF1051 / EWTNes 2956

23

Image 25
Contents Installation Instructions Please Read and Follow These Instructions To the Installer Table of Contents Installation Guidelines Planning Information Cabinet Opening DimensionsWF1051 Figure Side-By-Side WF1051 and RB1400 Figure 130 Planning Information Fig.A BGENes Reversing Door HingesUnscrew the lower hinge Finally mounting screw M4 Fig.D1-2 BGENes Door Opening Angle Figures 7Unpacking InstallationSpanner Built-in appliances with a wooden ventilation grille Fig.R BGENes Blocking for SafetyIcemaker Do not install the shut-off valve behind the applianceWater Connection Figure Solenoid valve is located at the rear of your unit Connection to the Water SupplyIcemaker Installation with SBS Ventilation Grille Set SIDE-BY-SIDE InstallationCa.210 Spanner Fig.Q BGENes Fig.S BGENes 31 Connect the appliancesSpanner At least 31 square inches 200cm2 per unit SIDE-BY-SIDE Installation