Multiquip STXD6i TROWeL safeTy, ENgINe safeTy, Order Form PT-160, Before servicing equipment

Page 10
DANGEROUS
GAS FUMES

Safety Information

TROWeL safeTy

daNgeR

„Engine fuel exhaust gases contain poisonous carbon monoxide. This gas is colorless and odorless, and can cause death if inhaled.

„The engine of this equipment requires an adequate free fl ow of cooling air. NeveR operate this equipment in any enclosed or narrow area

where free fl ow of the air is restricted. If the air fl ow is restricted it will cause injury

to people and property and serious damage to the equipment or engine.

„NeveR operate the equipment in an explosive atmosphere or near combustible materials.An explosion or fi re could result causing severe bodily harm or even death.

WaRNINg

„If applicable, NeveR use your hand to fi nd hydraulic leaks. Use a piece of wood or

cardboard. Hydraulic fl uid injected into the skin must be treated by a knowledgeable physician immediately or severe injury or death can occur.

„aLWays keep clear of rotating or moving parts while operating the trowel.

„NeveR disconnect any emergency or safety devices. These devices are intended for operator safety. Disconnection of these devices can cause severe injury, bodily harm or even death. Disconnection of any of these devices will void all warranties.

cauTION

„NeveR allow passengers or riders on the trowel during operation.

„NeveR lubricate components or attempt service on a running machine.

„NeveR place your feet or hands inside the guard rings while starting or operating this equipment.

NOTICE

„aLWays keep the machine in proper running condition.

„Fix damage to machine and replace any broken parts immediately.

„aLWays store equipment properly when it is not being used. Equipment should be stored in a clean, dry location out of the reach of children and unauthorized personnel.

„A safety manual for operating and maintenance personnel of concrete power trowels produced by the Association of Equipment Manufacturers (AEM) can be obtained for a fee by ordering through their website at www.aem.org.

Order FORM PT-160

eNgINe safeTy

WaRNINg

„dO NOT place hands or fingers inside engine compartment when engine is running.

„NeveR operate the engine with heat shields or guards removed.

„Keep fi ngers, hands hair and clothing away from all moving parts to prevent injury.

„dO NOT remove the radiator cap while the

engine is hot. High pressure boiling water will gush out of the radiator and severely scald any persons in the general area of the trowel.

„dO NOT remove the coolant drain plug while the engine is hot. Hot coolant will gush out of the coolant tank and severely scald any persons in the general area of the trowel.

„dO NOT remove the engine oil drain plug while the engine is hot. Hot oil will gush out of the oil tank and severely scald any persons in the general area of the trowel.

cauTION

„NeveR touch the hot exhaust manifold, muffl er or cylinder. Allow these parts to cool

before servicing equipment.

page 10 — stxd6i RIDE-ON TROWEL• operation manual — rev. #0 (03/23/12)

Image 10
Contents Model stxd6i Proposition 65 warning Silicosis/respiratory warnings Silicosis WarningTable of Contents Specifications are subject to change without noticePage Training checklist Training checklistCompletely Daily pre-operation checklist Daily pre-Operation checklistSafety Information SafeTy messagesGeNeRaL safeTy Order Form PT-160 TROWeL safeTyENgINe safeTy Before servicing equipmentBaTTeRy safeTy FueL safeTy„ Use well-insulated gloves when picking up the battery Lifting TRaNspORTINg safeTyTOWINg safeTy „ NeveR lift trowel with the operator on the machineEmission control Label ENvIRONmeNTaL safeTy/decOmmIssIONINgEmIssIONs INfORmaTION Label must remain with the engine for its entire lifeLifting the trowel Lifting and transportingTransporting the trowel Trowel Specifications SpecificationsEngine Specifications Width in. cm DimensionsTrowel Dimensions This value includes the seat height TableGeneral information Indicators ComponentsToolbox Compartment Storage for tools Basic engine Oil Filler Port Remove to add fresh crankcase oilEngine Oil InspectionHydraulic Oil Fuel „„ The ash content must not exceed 0.01% by volumeDetermine if the engine fuel is low Figure Setup Battery SetupOperation Insert the ignition key into the ignition switch FigureStarting the Engine Safety Interlock Battery ManagementSafety Interlocks Engine throttleHydraulic Oil Cooler Fan Control Power managementFault Alerting Red Stop Lamp Hydraulic Oil Filter MonitoringJoystick Directional Positioning Control Joystick Result DirectionPanning Mode Manual Mode Pitch Mode Light is OffSmart Pitch Mode Blade Pitch ControlEngine ShutDown Engine ShutdownMaintenance Maintenance ScheduleAir Cleaner Service Air CleanerRadiator/Cooling System Radiator Cleaning Fan Belt TensionRecommended Viscosity Grades Changing Engine Oil And FilterFuel Filter Replace the engine fuel filter element every 500 hoursOil And Fuel Lines Battery/Charging SystemFuel/Water Separator Engine Tune-UpInstalling Pans Onto Finisher Blades Long Term StorageTroubleshooting Troubleshooting Ride-On hydraulic TrowelWiring? Repair per engine repair manual Dipstick HERE’S HOW to GET Help