Multiquip STXD6i operation manual Inspection, Engine Oil, Hydraulic Oil

Page 21

inspection

NOTICE

The following sections are intended to assist the operator with inspection of the STXD6i Ride-On Trowel. It is extremely important that these sections are read carefully before attempting to use the trowel in the field. DO NOT use your Ride-On Trowel until these sections are thoroughly understood.

WARNING

Failure to understand the operation of the STXD6i Ride-On Trowel could result in personal injury or severe damage to the trowel.

Engine Oil

ENGINE OIL

FILLER CAP

DIPSTICK

FULL

F

 

 

 

ADD OIL

L

ENGINE OIL

 

 

FILLER CAP

Figure 7. Engine Oil Check and Fill

1.When checking or adding oil, place the machine so the engine is level.

2.Pull the engine oil dipstick from its holder, (Figure 7).

3.Determine if engine oil is low. Oil should be between the upper limit and lower limit (add oil) lines.

4.If oil is below the "Add Engine Oil" line add oil up to upper limit on the dipstick. Allow enough time for any added oil to make its way to the oil pan before rechecking.

CAUTION

DO NOT overfill the oil pan with engine oil. Always keep the engine oil level between the upper and lower limit lines on the dipstick.

Hydraulic Oil

1.Check the hydraulic oil condition through the sight glass (Figure 8) Replace hydraulic oil if dirty or if bubbles are present.

HYDRAULIC OIL

SIGHT GLASS

Figure 8. Hydraulic Oil Sight Glass

2.Determine if the hydraulic oil is low. The hydraulic tank has an elevated overflow bottle. DO NOT remove the fill cap when the oil is hot or spillage will occur.

CAUTION

Hydraulic oil can get HOT! ALWAYS allow hydraulic oil to cool before removing fill cap.

CAUTION

Removal of the fill cap when oil fills the sight glass will cause hydraulic oil to spill. Clean up hydraulic oil spills immediately.

3.To add hydraulic oil, remove fill cap on the hydraulic tank. Fill to overflow with hydraulic system cool. Use Chevron AW / MV ISO 68 or equivalent.

STXD6i RIDE-ON TROWEL • operation manual —rev. #0 (03/23/12) — page 21

Image 21
Contents Model stxd6i Proposition 65 warning Silicosis Warning Silicosis/respiratory warningsSpecifications are subject to change without notice Table of ContentsPage Training checklist Training checklistCompletely Daily pre-Operation checklist Daily pre-operation checklistSafeTy messages Safety InformationGeNeRaL safeTy ENgINe safeTy TROWeL safeTyOrder Form PT-160 Before servicing equipmentFueL safeTy BaTTeRy safeTy„ Use well-insulated gloves when picking up the battery TOWINg safeTy TRaNspORTINg safeTyLifting „ NeveR lift trowel with the operator on the machineEmIssIONs INfORmaTION ENvIRONmeNTaL safeTy/decOmmIssIONINgEmission control Label Label must remain with the engine for its entire lifeLifting and transporting Lifting the trowelTransporting the trowel Specifications Trowel SpecificationsEngine Specifications Trowel Dimensions DimensionsWidth in. cm This value includes the seat height TableGeneral information Components IndicatorsToolbox Compartment Storage for tools Oil Filler Port Remove to add fresh crankcase oil Basic engineInspection Engine OilHydraulic Oil „„ The ash content must not exceed 0.01% by volume FuelDetermine if the engine fuel is low Figure Battery Setup SetupInsert the ignition key into the ignition switch Figure OperationStarting the Engine Safety Interlocks Battery ManagementSafety Interlock Engine throttleFault Alerting Red Stop Lamp Power managementHydraulic Oil Cooler Fan Control Hydraulic Oil Filter MonitoringControl Joystick Result Direction Joystick Directional PositioningSmart Pitch Mode Manual Mode Pitch Mode Light is OffPanning Mode Blade Pitch ControlEngine Shutdown Engine ShutDownMaintenance Schedule MaintenanceAir Cleaner Air Cleaner ServiceRadiator/Cooling System Fan Belt Tension Radiator CleaningFuel Filter Changing Engine Oil And FilterRecommended Viscosity Grades Replace the engine fuel filter element every 500 hoursFuel/Water Separator Battery/Charging SystemOil And Fuel Lines Engine Tune-UpLong Term Storage Installing Pans Onto Finisher BladesTroubleshooting Ride-On hydraulic Trowel TroubleshootingWiring? Repair per engine repair manual Dipstick HERE’S HOW to GET Help