McIntosh MVP861 owner manual How to Set the Video, con’t, Still Mode

How to Set the Video, con’t

TV/Monitor. In order to view the Progressive Scan Video Output of the MVP861, the TV/ Monitor connected to it must be capable of displaying a Progressive Picture and setup to display the Progressive Signal.

3. To change from the Interlaced to Progressive Scan set- ting use the Up or Down directional Push-buttons followed by the SELECT Push-button.

Notes: The title of the icon button-bar will change color from yellow (the cursor color) to green indicating the selected item. Not all High definition TV/ Monitor sets are fully compatible with the MVP861 and may cause artifacts to be displayed in the picture. In the case of Progressive Scan picture problems, it is recommened to switch off the Progressive Scan feature in the MVP861 and instead use the built-in Progressive Scan feature of the TV/monitor. For additional information please contact your McIntosh Dealer.

4.Return to the Video Setup Menu by pressing the Up directional Push-button.

5.Next continue to the STILL MODE Settings. If no

other changes are to be made in Setup Mode at this time, exit by pressing the Down directional Push- button to select the EXIT SETUP menu choice fol- lowed by the SELECT Push-button and the MVP861 will return to normal operation.

Note: The SETUP Push-button may be also pressed to exit the setup mode.

Still Mode

The default setting of Automatic for the Still Mode of play- back allows for the viewing a single video frame at a time. If you encounter video picture jittering or fuzzy small text with a certain disc, select Field or Frame to correct the problem. To change from the default setting perform the following steps:

1. Press the SETUP Push-button on the supplied Remote Control to access the On-Screen Disc Setup Menu. Then press the Right directional Push-button to se- lect the Video Setup Menu Icon Tab. Refer to figure 12 on page 22.

Note: If there is a Disc playing in the MVP861 press the STOP Push-button twice before pressing the SETUP Push-button.

2. Use the Down directional Push-button followed by the SELECT Push-button on the Remote Control to se- lect the STILL MODE Menu. Refer to figure 19.

3. To change from the default setting use the Up or Down directional Push-buttons followed by the SE- LECT Push-button.

Figure 19

Figure 20

24