McIntosh MVP861 owner manual Lpcm 44.1kHz/48kHz

How to Set the Audio, con’t

2. To change from the default setting of Normal to PCM use the Up or Down directional Push-buttons to select DIGITAL OUT followed by the SELECT Push- button. Refer to figure 40 on page 31.

Notes: The title of the icon button-bar will change color from yellow (the cursor color) to green indicating the selected item.

3.Return to the Audio Setup Menu by pressing the Up directional Push-button.

4.Next continue to the LPCM (44.1kHz/48kHz) Menu. If no other changes are to be made in Setup Mode at this

time, exit by pressing the Down directional Push- button to select the EXIT SETUP menu choice fol- lowed by the SELECT Push-button and the MVP861 will return to normal operation.

Note: The SETUP Push-button may be also pressed to exit the setup mode.

LPCM (44.1kHz/48kHz)

The MVP861’s default setting is to make available at the Digital Outputs, the Digital Audio Signals of 96kHz or 88.2kHz from non-copyright protected DVDs. When the MVP861 is connected to a Digital-to-Analog Processing unit without the ability to process the higher digital sam- pling rate, the default setting can be changed to a 44.1kHz or 48kHz digital signal output by performing the following steps:

Notes: If the disk is copyright protected, the MVP861 will down convert the Digital Audio Signal to 44.1kHz or 48kHz. The MVP861’s internal digital to analog ciruitry will allways decode the highest sampling rate and will be available at the analog audio outputs.

1.Press the SETUP Push-button on the supplied Remote Control to access the On-Screen Disc Setup Menu.

Then press the Right directional Push-button to se- lect the Audio Setup Menu Icon Tab. Refer to figure 41.

Note: If there is a Disc playing in the MVP861 press the STOP Push-button twice before pressing the SETUP Push-button.

2. To change from the default setting of Off to On use the Up or Down directional Push-buttons to select LPCM (44.1kHz/48kHz) followed by the SELECT Push-button. Refer to figure 42.

Notes: The title of the icon button-bar will change color from yellow (the cursor color) to green indicating the selected item.

3.Return to the Audio Setup Menu by pressing the Up directional Push-button.

Figure 41

Figure 42

Figure 43

32