Multiquip STXD6i operation manual Battery Setup

Page 23

setup

The purpose of this section is to assist the user in setting up a new trowel. If your trowel is already assembled, (seat, handles, knobs and battery), this section can be skipped.

NOTICE

The new trowel cannot be put into service until the setup instructions are completed. These instructions only need to be performed at the time of unpacking a new trowel.

Battery Setup

CAUTION

Use all safety precautions specified by the battery manufacturer when working with the battery. See Safety Information section of this manual for more details on battery safety.

1.This trowel was shipped with a wet charged battery. This battery may need to be charged for a brief period of time as per manufacturer's instructions.

2.To install the battery on the trowel, make sure that the battery is well seated in the battery box (Figure 10).

Figure 10. Battery Box

3.Connect the positive cable to the positive terminal on the battery first, then connect the negative cable to the negative terminal.

4.Close the plastic battery box cover and secure the battery box.

STXD6i RIDE-ON TROWEL • operation manual —rev. #0 (03/23/12) — page 23

Image 23

Contents Model stxd6i Proposition 65 warning Silicosis Warning Silicosis/respiratory warningsSpecifications are subject to change without notice Table of ContentsPage Completely Training checklistTraining checklist Daily pre-Operation checklist Daily pre-operation checklistSafeTy messages Safety InformationGeNeRaL safeTy Before servicing equipment TROWeL safeTyENgINe safeTy Order Form PT-160„ Use well-insulated gloves when picking up the battery FueL safeTyBaTTeRy safeTy „ NeveR lift trowel with the operator on the machine TRaNspORTINg safeTyTOWINg safeTy LiftingLabel must remain with the engine for its entire life ENvIRONmeNTaL safeTy/decOmmIssIONINgEmIssIONs INfORmaTION Emission control LabelTransporting the trowel Lifting and transportingLifting the trowel Engine Specifications SpecificationsTrowel Specifications This value includes the seat height Table DimensionsTrowel Dimensions Width in. cmGeneral information Components IndicatorsToolbox Compartment Storage for tools Oil Filler Port Remove to add fresh crankcase oil Basic engineHydraulic Oil InspectionEngine Oil Determine if the engine fuel is low Figure „„ The ash content must not exceed 0.01% by volumeFuel Battery Setup SetupStarting the Engine Insert the ignition key into the ignition switch FigureOperation Engine throttle Battery ManagementSafety Interlocks Safety InterlockHydraulic Oil Filter Monitoring Power managementFault Alerting Red Stop Lamp Hydraulic Oil Cooler Fan ControlControl Joystick Result Direction Joystick Directional PositioningBlade Pitch Control Manual Mode Pitch Mode Light is OffSmart Pitch Mode Panning ModeEngine Shutdown Engine ShutDownMaintenance Schedule MaintenanceRadiator/Cooling System Air CleanerAir Cleaner Service Fan Belt Tension Radiator CleaningReplace the engine fuel filter element every 500 hours Changing Engine Oil And FilterFuel Filter Recommended Viscosity GradesEngine Tune-Up Battery/Charging SystemFuel/Water Separator Oil And Fuel LinesLong Term Storage Installing Pans Onto Finisher BladesTroubleshooting Ride-On hydraulic Trowel TroubleshootingWiring? Repair per engine repair manual Dipstick HERE’S HOW to GET Help