Multiquip STXD6i operation manual Air Cleaner Service, Radiator/Cooling System

Page 31

maintenance

CAUTION

Certain maintenance operations or machine adjustments require specialized knowledge and skill. Attempting to perform maintenance operations or adjustments without the proper knowledge, skills or training could result in equipment damage or injury to personnel. If in doubt, consult your dealer.

Air Cleaner

This Yanmar engine is equipped with a replaceable, high- density paper air cleaner element. Some will have an inner element that is used as a backup filter should the outer element becomes damaged.

See Figure 22 for air cleaner components.

ARROW

MARK

(CASE)

MAIN ARROW

ELEMENT MARK (DUST PAN)

Air Cleaner Service

CAUTION

Wear protective equipment such as approved safety glasses or face shields and dust masks or respirators when cleaning air filters with compressed air.

To service the air cleaner perform the following steps. See Figure 22 for location of parts.

4.

Release the latches located on either side of the air

 

cleaner dust pan. Remove the dust pan.

5.

Remove the air cleaner element.

6.

Blow low pressure air from the inside of the element

 

to dislodge the dust and dirt. Do not use excessive air

 

pressure or the element will be damaged and will need

 

to be replaced.

7.

Replace the element if it is damaged or excessively

 

dirty.

8.

Clean the inside of the dust pan.

9.

Reinstall the element or if equipped, the precleaner

AIR CLEANER

CASE

LATCH

DUST PAN

EVACUATOR

VALVE

over the paper air cleaner element.

10. Reinstall the air cleaner dust pan and secure the

latches.

NOTICE

DO NOT run the engine with the air cleaner removed or without an element.

Figure 22. Air Cleaner Components

1.Check the air cleaner daily or before starting the engine.

2.Check for and correct heavy buildup of dirt and debris along with loose or damaged components.

3.Replace the element if it is found to be damaged, excessively dirty, or oily.

NOTICE

Operating the engine with loose or damaged air cleaner components could allow unfiltered air into the engine causing premature wear and failure.

Radiator/Cooling System

CAUTION

HOT coolant can cause severe burns. DO

NOT remove cap if radiator is HOT.

1.Check radiator for leaks that would indicate corrosion or damage.

2.Check cooling water level daily. Top off as necessary. Always use clean, soft water and add a long life coolant antifreeze. Use the mixing ratios specified by the Antifreeze manufacturer. Replace cooling water at least once a year.

STXD6i RIDE-ON TROWEL • operation manual —rev. #0 (03/23/12) — page 31

Image 31
Contents Model stxd6i Proposition 65 warning Silicosis Warning Silicosis/respiratory warningsSpecifications are subject to change without notice Table of ContentsPage Training checklist Training checklistCompletely Daily pre-Operation checklist Daily pre-operation checklistSafeTy messages Safety InformationGeNeRaL safeTy Before servicing equipment TROWeL safeTyENgINe safeTy Order Form PT-160BaTTeRy safeTy FueL safeTy„ Use well-insulated gloves when picking up the battery „ NeveR lift trowel with the operator on the machine TRaNspORTINg safeTyTOWINg safeTy LiftingLabel must remain with the engine for its entire life ENvIRONmeNTaL safeTy/decOmmIssIONINgEmIssIONs INfORmaTION Emission control LabelLifting the trowel Lifting and transportingTransporting the trowel Trowel Specifications SpecificationsEngine Specifications This value includes the seat height Table DimensionsTrowel Dimensions Width in. cmGeneral information Components IndicatorsToolbox Compartment Storage for tools Oil Filler Port Remove to add fresh crankcase oil Basic engineEngine Oil InspectionHydraulic Oil Fuel „„ The ash content must not exceed 0.01% by volumeDetermine if the engine fuel is low Figure Battery Setup SetupOperation Insert the ignition key into the ignition switch FigureStarting the Engine Engine throttle Battery ManagementSafety Interlocks Safety InterlockHydraulic Oil Filter Monitoring Power managementFault Alerting Red Stop Lamp Hydraulic Oil Cooler Fan ControlControl Joystick Result Direction Joystick Directional PositioningBlade Pitch Control Manual Mode Pitch Mode Light is OffSmart Pitch Mode Panning ModeEngine Shutdown Engine ShutDownMaintenance Schedule MaintenanceAir Cleaner Service Air CleanerRadiator/Cooling System Fan Belt Tension Radiator CleaningReplace the engine fuel filter element every 500 hours Changing Engine Oil And FilterFuel Filter Recommended Viscosity GradesEngine Tune-Up Battery/Charging SystemFuel/Water Separator Oil And Fuel LinesLong Term Storage Installing Pans Onto Finisher BladesTroubleshooting Ride-On hydraulic Trowel TroubleshootingWiring? Repair per engine repair manual Dipstick HERE’S HOW to GET Help