Multiquip STXD6i operation manual Fuel, Determine if the engine fuel is low Figure

Page 22

inspection

Fuel

1. Determine if the engine fuel is low (Figure 9).

FUEL

EF

Figure 9. Fuel Gauge

2.If fuel level is low, remove the fuel filler cap and fill with ASTM D975 No1D or No. 2D diesel fuel. Handle fuel safely. Motor fuels are highly flammable and can be dangerous if mishandled.

3.Below are additional technical fuel requirements:

„„ The fuel cetane number should be equal to 45 or higher.

„„ The carbon residue content must not exceed 0.01% by volume. Less than 0.1% is preferred.

„„ The total aromatics content should not exceed 35% by volume. Less than 30% is preferred.

„„ The PAH (polycyclic aromatic hydrocarbons ) content should be below 10% by volume.

„„ The metal content of Na, Mg, Si, and Al should be equal or lower than 1 mass ppm.

„„ Lubricity: The wear mark of WS1.4 should be Max 0.018 in (µm) at HFRR test.

„„ This trowel can use biodesel fuel. Refer to the Yanmar Service manual for details.

CAUTION

DO NOT smoke while refueling. DO NOT attempt to refuel the ride-on trowel if the engine is hot or running.

„„ The sulfur content must not exceed 0.5% by volume. Less than 0.05% is preferred. For electronically-controlled engines, it is mandatory to use fuel that does not contain 0.1% or more sulfur content.

In general, using a high sulfur fuel may possible result in corrosion inside the cylinder. Low sulfur (300-500 mg/kg sulfur content) or ultra low sulfur fuel should be used.

„„ Never mix kerosene, used engine oil, or residual fuels with the diesel fuel.

„„ The water and sediment in the fuel should not exceed 0.05% by volume.

„„ Keep the fuel tank and fuel-handling equipment clean at all times.

„„ Poor quality fuel can reduce engine performance and/or cause engine damage.

„„ Fuel additives are not recommended. Some fuel additives may cause poor engine performance.

„„ The ash content must not exceed 0.01% by volume.

CAUTION

DO NOT store the Ride-On Trowel with fuel in the tank for an extended period of time. Completely drain the fuel system (tank, lines, etc.) if the unit is to be put into long term storage. For shorter or intermediate periods of time the tank should be filled to avoid condensation that could cause contamination of the fuel.

page 22 — stxd6i RIDE-ON TROWEL• operation manual — rev. #0 (03/23/12)

Image 22
Contents Model stxd6i Proposition 65 warning Silicosis/respiratory warnings Silicosis WarningTable of Contents Specifications are subject to change without noticePage Training checklist Training checklistCompletely Daily pre-operation checklist Daily pre-Operation checklistSafety Information SafeTy messagesGeNeRaL safeTy Order Form PT-160 TROWeL safeTyENgINe safeTy Before servicing equipmentBaTTeRy safeTy FueL safeTy„ Use well-insulated gloves when picking up the battery Lifting TRaNspORTINg safeTyTOWINg safeTy „ NeveR lift trowel with the operator on the machineEmission control Label ENvIRONmeNTaL safeTy/decOmmIssIONINgEmIssIONs INfORmaTION Label must remain with the engine for its entire lifeLifting the trowel Lifting and transportingTransporting the trowel Trowel Specifications SpecificationsEngine Specifications Width in. cm DimensionsTrowel Dimensions This value includes the seat height TableGeneral information Indicators ComponentsToolbox Compartment Storage for tools Basic engine Oil Filler Port Remove to add fresh crankcase oilEngine Oil InspectionHydraulic Oil Fuel „„ The ash content must not exceed 0.01% by volumeDetermine if the engine fuel is low Figure Setup Battery SetupOperation Insert the ignition key into the ignition switch FigureStarting the Engine Safety Interlock Battery ManagementSafety Interlocks Engine throttleHydraulic Oil Cooler Fan Control Power managementFault Alerting Red Stop Lamp Hydraulic Oil Filter MonitoringJoystick Directional Positioning Control Joystick Result DirectionPanning Mode Manual Mode Pitch Mode Light is OffSmart Pitch Mode Blade Pitch ControlEngine ShutDown Engine ShutdownMaintenance Maintenance ScheduleAir Cleaner Service Air CleanerRadiator/Cooling System Radiator Cleaning Fan Belt TensionRecommended Viscosity Grades Changing Engine Oil And FilterFuel Filter Replace the engine fuel filter element every 500 hoursOil And Fuel Lines Battery/Charging SystemFuel/Water Separator Engine Tune-UpInstalling Pans Onto Finisher Blades Long Term StorageTroubleshooting Troubleshooting Ride-On hydraulic TrowelWiring? Repair per engine repair manual Dipstick HERE’S HOW to GET Help