Multiquip STXD6i Lifting and transporting, Lifting the trowel, Transporting the trowel

Page 14

lifting and transporting

lifting the trowel

When lifting trowel for moving or transporting, do the following (see Figure 1).

transporting the trowel

After trowel has been lifted onto a flatbed truck, do the following:

3.Attach suitable tie-down straps to the trowel. Route tie-down straps on both sides as shown in Figure 2.

Figure 1. Lifting the Trowel

1.Secure two lifting straps to the lift loops located on the left and right side of the trowel.

2.To lift, insert forklift forks through loops at the end of lifting straps.

NOTICE

Ensure forklift has adequate lifting capacity for lifting the trowel.

LEFT

Figure 2. Routing Tie-down Straps

4.Secure the trowel to the flatbed with the two straps, making sure they are properly tied, to prevent movement of the trowel during transport.

page 14 — stxd6i RIDE-ON TROWEL• operation manual — rev. #0 (03/23/12)

Image 14
Contents Model stxd6i Proposition 65 warning Silicosis/respiratory warnings Silicosis WarningTable of Contents Specifications are subject to change without noticePage Completely Training checklistTraining checklist Daily pre-operation checklist Daily pre-Operation checklistSafety Information SafeTy messagesGeNeRaL safeTy Order Form PT-160 TROWeL safeTyENgINe safeTy Before servicing equipment„ Use well-insulated gloves when picking up the battery FueL safeTyBaTTeRy safeTy Lifting TRaNspORTINg safeTyTOWINg safeTy „ NeveR lift trowel with the operator on the machineEmission control Label ENvIRONmeNTaL safeTy/decOmmIssIONINgEmIssIONs INfORmaTION Label must remain with the engine for its entire lifeTransporting the trowel Lifting and transportingLifting the trowel Engine Specifications SpecificationsTrowel Specifications Width in. cm DimensionsTrowel Dimensions This value includes the seat height TableGeneral information Indicators ComponentsToolbox Compartment Storage for tools Basic engine Oil Filler Port Remove to add fresh crankcase oilHydraulic Oil InspectionEngine Oil Determine if the engine fuel is low Figure „„ The ash content must not exceed 0.01% by volumeFuel Setup Battery SetupStarting the Engine Insert the ignition key into the ignition switch FigureOperation Safety Interlock Battery ManagementSafety Interlocks Engine throttleHydraulic Oil Cooler Fan Control Power managementFault Alerting Red Stop Lamp Hydraulic Oil Filter MonitoringJoystick Directional Positioning Control Joystick Result DirectionPanning Mode Manual Mode Pitch Mode Light is OffSmart Pitch Mode Blade Pitch ControlEngine ShutDown Engine ShutdownMaintenance Maintenance ScheduleRadiator/Cooling System Air CleanerAir Cleaner Service Radiator Cleaning Fan Belt TensionRecommended Viscosity Grades Changing Engine Oil And FilterFuel Filter Replace the engine fuel filter element every 500 hoursOil And Fuel Lines Battery/Charging SystemFuel/Water Separator Engine Tune-UpInstalling Pans Onto Finisher Blades Long Term StorageTroubleshooting Troubleshooting Ride-On hydraulic TrowelWiring? Repair per engine repair manual Dipstick HERE’S HOW to GET Help