Smeg SC112 manual Extraordinary Maintenance, Changing the light bulb

Page 33

Instructions for the user

10. EXTRAORDINARY MAINTENANCE

The oven may require extraordinary maintenance or replacement of parts subject to wear such as seals, bulbs, and so on. The following instructions describe how to carry out these minor maintenance operations.

Before any intervention disconnect the power supply of the device.

10.1 Changing the light bulb

Remove the bulb protector A by turning it anticlockwise and replace bulb B with a similar one (25 W). Re-fit the bulb protector A.

Use only oven bulbs (T 500°C) (only for pyrolytic models). Use only oven bulbs (T 300°C) (only for multifunction models).

10.2 Removing the door 10.2.1 With moveable levers

With the door completely open, lift the levers A of the two hinges until they

touch the hinges B and

take hold of the two sides

of the door with both

hands close to the hinges

themselves.

Raise the door to an angle of about 45° and remove it. If the hinges have not locked, repeat the operation, raising the levers A and keeping the door slightly raised. To reassemble, fit the hinges B into their grooves, then lower the door into place, ensuring that it remains fitted into the grooves C, then lower the levers A.

35

Image 33

Contents Table of contents Instructions for USE General instructionsSafety Instructions Instructions for Disposal OUR Environmental Care Instructions for disposalGET to Know Your Oven Before InstallationPastry plate on some models only for baking Available AccessoriesRotisserie frame on some models only Chromium-plated gripper on some modelsGeneral Description Oven racks Using the OvenCooling system Inside lightDescription of the controls on the front panel DSP1Display for the function required, or the temperature Setting the current time STAND-BY setting with DSP1 onOperating modes First useChanging the preset temperature Cooking with preset temperatureUsing the minute minder Modifying the data setProgrammed cooking procedures Semiautomatic cookingAutomatic cooking Instructions for the user Selecting a recipe Modifying the data set during cookingAutomatic cooking with a recipe Selecting a recipe permanently Type Table of predefined recipesSecondary menu ECO Cooking with the OvenStatic GrillVentilated Static Bottom + Circular VentilatedVentilated Grill Ventilated BottomTurbo ThawingProving General Hints Hints on Using the AccessoriesCooking Hints for Meat Cooking Hints for Desserts and BiscuitsHints for Thawing and Proving Instructions for the user Oven when Cooking tablesDesserts Using other functionsRotisserie Cooking on Pyrolytic Models only Use of the pizza plate on some models only Precautions for using the pizza plateCleaning stainless steel Cleaning and MaintenanceOrdinary daily cleaning Food stains or residuesCleaning the inside of the oven Cleaning the door glazing Pyrolysis automatic oven cleaning on some models only Before starting the automatic cleaning cycle90 MIN 135 MIN 180 MIN Cleaning cycle will be shown on DSP1 Setting the cleaning cycleExtraordinary Maintenance Changing the light bulbRemoving the door 10.2.1 With moveable levers Removing the door seal Removing doors with pinsCleaning Removing the internal glass panelsRemoving the middle glass Replacing the glass Removing the 2nd middle glass pane Removing the 1st middle glass paneInstructions for the user ERR What to do ifInstalling the Appliance Electrical connectionOperation at 220-240 V~ use a type Positioning the oven Instructions for the installer