Smeg SC112 manual What to do if, Err

Instructions for the user

10.5 What to do if.

The oven display is full	• Check the mains power supply.
off	• Check		whether an omnipolar switch
		upstream from the oven feed line is in the
		“ON” position.
The oven does not	• Check whether the “showroom” mode has
heat up		been set, for further details see paragraph
		“Secondary menu” at page 19.
The controls do not	• Check whether the “child lock-out function”
respond.		mode has been set, for further details see
		paragraph “Secondary menu” at page 19.
The cooking times are	• Check whether the “2300 W” mode has been
longer than those		set, for further details see paragraph
indicated in the table.		“Secondary menu” at page 19.
After the automatic	•	Verify	whether the		interlock		device	has
“pyrolysis” cleaning		switched off. If it has not, the oven has a
cycle (only on some		protection		device	that	does	not	allow
models) it is not		functions to be selected while the interlock
possible to select a
		device	is	active.	This	is because		the
function.
		temperatures inside the oven are still too
		high to permit any type of cooking.
The display shows	• The interlock device has not hooked up to
ERR 4		the door properly. These might be because
(on pyrolytic models		the door was accidentally opened during its
only)		activation. Switch off the oven and switch it
		on again waiting a few minutes before
		selecting a new cleaning cycle.
If the door is opened	•	This is not a fault. It is a normal operation of
during a ventilated		the appliance, useful for when cooking foods
function, the fans		to avoid excessive heat escaping. When the
stops.		door is closed, the oven will return to normal

operation.

If the problem has not been resolved or for other types of faults, contact your local technical assistance centre.

41