Andrew ES45T manual Upper

Step 5

Step 6

Loosely attach support angles (P/N 49622) to the upper azimuth axis joint (P/N 300748) and the connection plates (part of P/N 49635)as shown in Figure 8.

•Use A-325 ½ x 1-½ in. bolts, flatwashers and nuts. (see page 12)

•Angles should be attached with flat of angle facing upward

•Loosely attach support angles to azimuth axis joint (P/N 49629)

300748

UPPER

Figure 8

Apply a liberal amount of grease (P/N 49208) to azimuth axis support (P/N 49634) and corresponding underside of azimuth axis joint as shown in Figure 9.

Figure 9

16 Installation Procedures